Phone · Motorola · Moto Edge Plus 2023
Motorola Moto Edge Plus 2023 Speaker Repair
Speaker Repair guide for the Motorola Moto Edge Plus 2023
Before you begin
Tools
- Heat gun or heating pad
- Precision screwdriver set
- Plastic opening picks
- Suction cup
- Spudger
- SIM eject tool
Parts / materials
- Pre-cut rear cover adhesive strips
- 99% Isopropyl alcohol
- Lint-free cleaning cloth
Safety
- Wear eye protection when heating glass panels to avoid injury from accidental thermal cracks.
- Disconnect the battery before touching internal components to prevent short circuits.
- Do not puncture or bend the internal battery during disassembly.
Overview
Step-by-step
- 1
Power Off the Device
1 minPress and hold the Power and Volume Up buttons simultaneously, then tap Power Off on the screen.
- 2
Eject the SIM Tray
1 minInsert a SIM eject tool into the hole on the bottom frame and push to release the tray.
- 3
Heat the Back Panel
2 minApply heat to the edges of the rear glass using a heat gun on low setting for two minutes to soften adhesive.
- 4
Attach Suction Cup
1 minPlace a suction cup on the lower portion of the rear glass cover and pull upward to create a slight gap.
- 5
Slice Rear Glass Adhesive
4 minInsert an opening pick into the gap and slide it along all four edges to slice through the perimeter tape.
- 6
Remove Rear Glass Cover
1 minCarefully lift the rear glass panel away from the chassis and place it on a clean surface.
- 7
Unscrew Wireless Charging Plate
3 minRemove the Phillips #00 screws securing the upper midframe plastic overlay and wireless charging coil.
- 8
Detach Wireless Charging Assembly
2 minGently pry up and lift off the upper wireless charging assembly from the motherboard frame.
- 9
Disconnect the Battery
1 minUse a plastic spudger to pop the battery flex connector straight off the motherboard socket.
- 10
Unscrew Loudspeaker Module
2 minRemove the Phillips screws securing the lower speaker enclosure to the bottom chassis frame.
- 11
Pry Out Damaged Speaker
2 minInsert the flat end of a spudger beneath the speaker module notch and gently lever it out of its recess.
- 12
Install Replacement Speaker
2 minPosition the new loudspeaker assembly into the bottom housing and press down until it sits flush.
- 13
Secure Loudspeaker Module
2 minReinstall and tighten the Phillips screws to hold the new loudspeaker module in place.
- 14
Reconnect Battery Cable
1 minAlign the battery flex connector over its terminal and press down until it snaps into place.
- 15
Reinstall Wireless Charging Plate
3 minSet the wireless charging assembly over the motherboard and tighten all associated Phillips screws.
- 16
Apply Fresh Back Cover Adhesive
3 minClean remaining adhesive off the frame using isopropyl alcohol, then lay down fresh cut adhesive strips.
- 17
Reseal the Rear Glass
2 minAlign the rear glass cover with the phone body and press firmly along the perimeter to secure the seal.
After your Motorola Moto Edge Plus 2023 speaker repair
Power the Moto Edge Plus 2023 back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto Edge Plus 2023 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Prefer a professional repair?
Book Motorola Moto Edge Plus 2023 speaker repair at LML Repair in Seattle — same-day options available.
