Phone · Motorola · Moto Edge Plus 2022
Motorola Moto Edge Plus 2022 Speaker Repair
Speaker Repair guide for the Motorola Moto Edge Plus 2022
Before you begin
Tools
- Heat gun or hair dryer
- Suction cup tool
- Plastic prying tools
- Phillips #000 screwdriver
- Spudger tool
- Tweezers
Parts / materials
- Replacement Moto Edge Plus 2022 loudspeaker module
- Pre-cut rear glass adhesive sticker
- Isopropyl alcohol (70% or higher)
- Lint-free microfiber cloth
Safety
- Wear safety glasses to protect against potential glass fragments during rear glass removal.
- Do not overheat the device to avoid damaging the internal Li-ion battery.
- Use plastic opening tools near the battery to prevent accidental punctures or shorts.
Overview
Step-by-step
- 1
Power off device
1 minPress and hold the power button, then select Power Off on the screen to shut down the phone completely.
- 2
Heat the rear panel
2 minApply heat around the outer edges of the rear glass for 2 minutes to soften the underlying adhesive.
- 3
Apply suction cup
1 minPress a suction cup firmly onto the lower portion of the rear glass near the bottom edge.
- 4
Insert opening pick
2 minPull up on the suction cup to create a thin gap, then insert a plastic opening pick between the glass and frame.
- 5
Slice perimeter adhesive
4 minSlide the plastic pick around all four edges of the back cover to cut through the adhesive seal.
- 6
Remove the back glass
1 minGently lift the back glass off the chassis and set it aside on a clean surface.
- 7
Unscrew upper cover
3 minUse a Phillips #000 screwdriver to remove the screws holding the upper midframe and wireless charging shroud.
- 8
Detach wireless coil
2 minCarefully peel up the wireless charging coil pad to access the lower board area.
- 9
Unscrew loudspeaker housing
2 minRemove the Phillips #000 screws securing the loudspeaker assembly at the bottom of the phone.
- 10
Pry loudspeaker module
2 minInsert the flat end of a spudger under the edge of the loudspeaker module and gently pry up.
- 11
Remove old loudspeaker
1 minLift the loudspeaker housing out of the bottom chassis cavity.
- 12
Insert new loudspeaker
2 minPlace the new replacement loudspeaker module directly into the lower frame cavity.
- 13
Secure loudspeaker housing
2 minReinstall and tighten the Phillips screws to hold the loudspeaker firmly in place.
- 14
Reattach wireless coil
3 minLay the wireless charging coil back over the motherboard and reinstall its retaining screws.
- 15
Clean frame adhesive
4 minUse isopropyl alcohol and a microfiber cloth to scrape away leftover adhesive from the frame and back glass.
- 16
Apply fresh adhesive
3 minLine up the pre-cut rear glass adhesive strip along the perimeter of the frame and press it down.
- 17
Seal rear panel
2 minAlign the back glass onto the frame and apply firm pressure around all edges to secure the water-resistant seal.
After your Motorola Moto Edge Plus 2022 speaker repair
Power the Moto Edge Plus 2022 back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto Edge Plus 2022 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Prefer a professional repair?
Book Motorola Moto Edge Plus 2022 speaker repair at LML Repair in Seattle — same-day options available.
