Phone · Motorola · Moto Edge 60 Pro
Motorola Moto Edge 60 Pro Logic Board Repair
Logic Board Repair guide for the Motorola Moto Edge 60 Pro
Before you begin
Tools
- Precision screwdriver set (Phillips #000)
- Heat gun or hair dryer
- Suction cup tool
- Plastic prying tools
- Spudger tool
- Tweezers
- SIM eject tool
Parts / materials
- Replacement back cover adhesive tape
- Isopropyl alcohol (99%)
- Thermal pad / thermal paste
Safety
- Wear safety glasses when applying heat to glass panels.
- Disconnect the battery before handling any electrical connectors on the logic board.
- Use an anti-static wrist strap to prevent electrostatic discharge damage to fragile surface-mount components.
Overview
Step-by-step
- 1
Eject SIM Tray
1 minInsert a SIM eject tool into the pinhole on the bottom frame to release the tray. Pull the SIM card tray completely out of the frame.
- 2
Heat Rear Glass
3 minApply heat around the edges of the back cover with a heat gun for 2 to 3 minutes to soften the adhesive.
- 3
Attach Suction Cup
2 minPress a suction cup onto the lower portion of the back panel. Pull upward steadily to create a micro-gap near the USB port.
- 4
Slice Edge Adhesive
4 minInsert a plastic opening pick into the gap and slide it along the perimeter to slice through the back cover adhesive.
- 5
Detach Rear Glass
1 minLift the rear glass cover off the device frame and set it aside on a clean surface.
- 6
Unscrew Upper Bracket
3 minRemove the Phillips #000 screws securing the motherboard protective cover and wireless charging pad.
- 7
Remove Upper Cover Plate
1 minGently pry up and remove the plastic upper frame cover with embedded wireless charging coil.
- 8
Disconnect Battery Flex
1 minUse a plastic spudger to pop the main battery connector straight up from the motherboard terminal.
- 9
Disconnect Interconnect Cables
2 minUnsnap the display ribbon, main interconnect cable, and side button flex connectors from the logic board.
- 10
Disconnect Antenna Cables
2 minUse tweezers to carefully lift the small coaxial antenna connectors away from the board surface.
- 11
Remove Board Screws
2 minUnscrew the remaining Phillips #000 screws anchoring the main logic board to the inner chassis.
- 12
Lift Logic Board Out
2 minInsert a spudger beneath the corner of the logic board and leverage it gently out of the frame.
- 13
Transfer Camera Modules
3 minDisconnect the front and rear camera modules from the old board using tweezers and install them onto the replacement board.
- 14
Seat Replacement Board
2 minPosition the replacement logic board into the frame, ensuring no flex cables are trapped beneath it.
After your Motorola Moto Edge 60 Pro logic board repair
Power the Moto Edge 60 Pro back on and test the logic board repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto Edge 60 Pro job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Prefer a professional repair?
Book Motorola Moto Edge 60 Pro logic board repair at LML Repair in Seattle — same-day options available.
