Phone · Motorola · Moto Edge 5G 2020
Motorola Moto Edge 5G 2020 Speaker Repair
Speaker Repair guide for the Motorola Moto Edge 5G 2020
Before you begin
Tools
- Heat gun or hair dryer
- Suction cup tool
- Plastic opening pick
- Spudger tool
- Phillips #000 screwdriver
- Tweezers
Parts / materials
- Replacement loudspeaker module for Moto Edge 5G 2020
- Pre-cut rear glass adhesive strip
- Isopropyl alcohol (optional for cleaning adhesive)
Safety
- Wear safety glasses to protect your eyes in case the rear glass cracks during removal.
- Do not heat the rear glass beyond 80°C (176°F) to avoid damaging internal battery and display components.
- Ensure the phone is fully powered off before starting any disassembly.
Overview
Step-by-step
- 1
Power off the device
1 minPress and hold the power button, then tap Power Off on the screen to ensure the device is completely powered down.
- 2
Heat the back glass
2 minApply heat to the edges of the rear glass using a heat gun or hair dryer on low for two minutes to soften the perimeter adhesive.
- 3
Attach the suction cup
1 minPlace a suction cup near the bottom edge of the back glass and pull upward gently to create a small seam.
- 4
Insert an opening pick
1 minInsert a thin plastic opening pick into the seam between the curved back glass and the frame.
- 5
Slice perimeter adhesive
4 minSlide the pick carefully along all four edges of the back cover to cut through the remaining adhesive.
- 6
Remove the back glass
1 minLift the rear glass cover off the frame and set it aside in a safe, dust-free location.
- 7
Remove bottom cover screws
3 minUse a Phillips #000 screwdriver to remove the screws securing the lower loudspeaker housing cover.
- 8
Pry up the loudspeaker assembly
2 minInsert the flat end of a spudger under the edge of the loudspeaker assembly and gently pop it out of the frame.
- 9
Clean the speaker recess
2 minUse tweezers or a soft brush to remove any dust or old adhesive residue from the bottom speaker cavity.
- 10
Position the new speaker module
2 minAlign the replacement loudspeaker module with the gold spring contact pins on the sub-board.
- 11
Press the speaker into place
1 minGently press down on the speaker assembly until it snaps flush into the phone frame.
- 12
Reinstall housing screws
3 minInsert and tighten all Phillips #000 screws to secure the speaker module housing firmly in place.
- 13
Clean old glass adhesive
3 minPeel away old adhesive strips from the inner rim of the phone frame and the back glass using a spudger.
- 14
Apply replacement adhesive
3 minLay down fresh pre-cut adhesive tape along the perimeter edges of the rear frame.
- 15
Reattach the back glass
2 minAlign the rear glass cover over the frame and press around the perimeter firmly to seal the device.
After your Motorola Moto Edge 5G 2020 speaker repair
Power the Moto Edge 5G 2020 back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto Edge 5G 2020 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Prefer a professional repair?
Book Motorola Moto Edge 5G 2020 speaker repair at LML Repair in Seattle — same-day options available.
