Phone · Motorola · Moto Edge 50 Fusion 5G
Motorola Moto Edge 50 Fusion 5G Speaker Repair
Speaker Repair guide for the Motorola Moto Edge 50 Fusion 5G
Before you begin
Tools
- Heat gun or hair dryer
- Suction cup tool
- Plastic prying tools
- Precision screwdriver set (Phillips #00)
- Spudger tool
- SIM eject tool
- Tweezers
Parts / materials
- Replacement Moto Edge 50 Fusion loudspeaker module
- Pre-cut rear cover adhesive sticker
- Isopropyl alcohol (99%)
- Lint-free microfiber swab
Safety
- Wear safety glasses to protect your eyes from debris or heat-softened plastics.
- Do not overheat the phone frame to avoid damaging internal components or the battery.
- Use non-conductive plastic tools near exposed circuit boards to prevent electrical shorts.
Overview
Step-by-step
- 1
Power off the device
1 minPress and hold the power button, then select Power Off on the screen to shut down the phone completely.
- 2
Eject the SIM tray
1 minInsert a SIM eject tool or paperclip into the small hole on the bottom edge to remove the SIM card tray.
- 3
Heat the rear cover edges
2 minApply a heat gun or hair dryer to the perimeter of the back panel for two minutes to soften the adhesive.
- 4
Attach the suction cup
1 minPress a suction cup firmly onto the lower section of the rear cover and pull upward to form a small gap.
- 5
Insert a plastic opening pick
1 minSlide a thin plastic pick into the gap created between the back panel and the outer frame.
- 6
Slice perimeter adhesive
3 minGuide the opening pick along all four edges of the back cover to cut through the remaining adhesive.
- 7
Remove the rear cover
1 minLift the rear panel away from the phone body and set it aside safely.
- 8
Unscrew the loudspeaker module
2 minUse a Phillips #00 screwdriver to remove all screws securing the lower loudspeaker housing.
- 9
Pry up the loudspeaker
1 minInsert the flat end of a spudger under the speaker module notch and gently lever it up from the frame.
- 10
Clean the sub-board contact pads
2 minLightly wipe the gold spring contact pads on the daughterboard using a swab dipped in isopropyl alcohol.
- 11
Position the new loudspeaker
1 minSet the replacement loudspeaker module into the lower cavity of the frame until it aligns with the screw holes.
- 12
Reinstall loudspeaker screws
2 minThread and tighten all Phillips #00 screws clockwise until snug to secure the speaker module.
- 13
Apply back cover adhesive
3 minClean remaining adhesive from the frame and lay new pre-cut adhesive strips along the edges.
- 14
Seal the rear cover
2 minAlign the rear panel with the frame and press firmly along the perimeter to secure the bond.
After your Motorola Moto Edge 50 Fusion 5G speaker repair
Power the Moto Edge 50 Fusion 5G back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto Edge 50 Fusion 5G job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Prefer a professional repair?
Book Motorola Moto Edge 50 Fusion 5G speaker repair at LML Repair in Seattle — same-day options available.
