Skip to main content

Phone · Samsung · Galaxy Z Fold 4 5G

Samsung Galaxy Z Fold 4 5G Battery Replacement

Battery Replacement guide for the Samsung Galaxy Z Fold 4 5G

Moderate
~47 min
18 steps

Before you begin

Tools

  • Phillips #00 screwdriver
  • Heat gun or iOpener
  • Suction handle
  • Opening picks
  • Spudger
  • Tweezers
  • Plastic opening cards

Parts / materials

  • Replacement dual battery set for Galaxy Z Fold 4
  • Pre-cut battery adhesive strips
  • Back glass replacement adhesive seals
  • High-concentration isopropyl alcohol (99%)

Safety

  • Discharge both batteries below 25% before starting the repair to prevent thermal runaway if damaged.
  • Never use sharp metal tools or puncture the lithium-ion batteries.
  • Wear eye protection when heating glass panels and prying near adhesives.

Overview

# Samsung Galaxy Z Fold 4 5G Battery Replacement Repair Guide Action-specific battery replacement walkthrough for the Samsung Galaxy Z Fold 4 5G. About 47 minutes across 18 steps. This DIY guide walks through battery replacement on the Samsung Galaxy Z Fold 4 5G (Galaxy Z series phone). Before you open the device, confirm the exact model number on the Samsung settings screen or rear housing so your replacement part matches the Galaxy Z Fold 4 5G specifically—not a similar Galaxy Z sibling. Most DIY techs finish this Samsung Galaxy Z Fold 4 5G battery replacement in about 47 minutes when parts and tools are ready. Difficulty is rated intermediate for this model. Recommended tools for this Samsung Galaxy Z Fold 4 5G job: Phillips #00 screwdriver, Heat gun or iOpener, Suction handle, Opening picks, Spudger, Tweezers, Plastic opening cards. Parts and supplies: Replacement dual battery set for Galaxy Z Fold 4, Pre-cut battery adhesive strips, Back glass replacement adhesive seals, High-concentration isopropyl alcohol (99%). Power the Galaxy Z Fold 4 5G off completely, remove SIMs/SD cards if present, and work on a clean, well-lit surface with a magnetic mat for screws. If a step feels wrong for your Samsung Galaxy Z Fold 4 5G, stop and compare the connector layout to the photos in this guide. When you prefer a same-day pro repair in Seattle instead, LML Repair can handle battery replacement for this model with tested parts and a workmanship warranty.

Step-by-step

  1. 1

    Power off the device

    1 min

    Press and hold the side button along with the volume down button, then tap Power Off on the screen.

  2. 2

    Heat the primary rear cover

    2 min

    Apply a heated iOpener or heat gun to the edges of the right-side back glass panel for two minutes to soften the adhesive.

  3. 3

    Slice the primary rear cover adhesive

    4 min

    Attach a suction cup near the bottom edge, pull up firmly to create a gap, and insert an opening pick into the seam.

  4. 4

    Remove the primary back glass

    3 min

    Slide the pick carefully around all edges to slice through the adhesive, then lift off the back glass panel.

  5. 5

    Unscrew the wireless charging coil

    3 min

    Use a Phillips #00 screwdriver to remove the 10 screws securing the wireless charging coil and mid-frame bracket.

  6. 6

    Disconnect the wireless charging coil

    1 min

    Use the pointed end of a spudger to pop off the wireless charging coil press connector from the motherboard.

  7. 7

    Remove the wireless charging coil assembly

    2 min

    Peel up the graphite sheet and carefully lift the wireless charging coil assembly out of the chassis.

  8. 8

    Disconnect the primary battery

    1 min

    Pry the primary battery press connector straight up from its socket to prevent electrical short circuits during repair.

  9. 9

    Heat the secondary back glass panel

    2 min

    Apply a heated iOpener or heat gun to the left-side cover glass panel for two minutes.

  10. 10

    Slice the secondary rear panel adhesive

    4 min

    Place a suction cup on the glass, pull to create a gap, and slide an opening pick under the edge.

  11. 11

    Remove the secondary back glass

    2 min

    Cut through all remaining perimeter adhesive with the pick and lift the secondary back panel off the frame.

  12. 12

    Unscrew the lower loudspeaker housing

    2 min

    Remove the Phillips #00 screws securing the bottom speaker shield on the secondary battery side.

  13. 13

    Disconnect the secondary battery

    1 min

    Use a plastic spudger to disconnect the secondary battery flex cable from the main motherboard.

  14. 14

    Apply isopropyl alcohol to the primary battery

    3 min

    Apply high-concentration isopropyl alcohol along the edges of the primary battery to soften the strong adhesive beneath it.

  15. 15

    Pry out the primary battery

    5 min

    Insert a flat plastic card or heavy-duty opening pick under the primary battery and gently lift it out of its well.

  16. 16

    Apply isopropyl alcohol to the secondary battery

    3 min

    Drip a small amount of isopropyl alcohol along the sides of the secondary battery and wait 2 minutes.

  17. 17

    Pry out the secondary battery

    4 min

    Work a plastic opening tool under the secondary battery and slowly lever it up until it detaches from the frame.

  18. 18

    Install replacement batteries with fresh adhesive

    4 min

    Clean remaining adhesive from the battery wells, apply pre-cut adhesive strips, and press the new batteries firmly into place.

After your Samsung Galaxy Z Fold 4 5G battery replacement

Power the Galaxy Z Fold 4 5G back on and test the battery replacement function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Samsung Galaxy Z Fold 4 5G job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.

Prefer a professional repair?

Book Samsung Galaxy Z Fold 4 5G battery replacement at LML Repair in Seattle — same-day options available.