Skip to main content

Phone · Samsung · Galaxy Fold 4G

Samsung Galaxy Fold 4G Battery Replacement

Battery Replacement guide for the Samsung Galaxy Fold 4G

Moderate
~64 min
19 steps

Before you begin

Tools

  • Heat gun or hair dryer
  • Suction cup tool
  • Plastic prying tools
  • Precision screwdriver set (Phillips #00)
  • Spudger tool
  • Tweezers
  • Anti-static wrist strap

Parts / materials

  • Isopropyl alcohol
  • Battery adhesive removal strips
  • Pre-cut back cover adhesive gaskets

Safety

  • Discharge device battery below 25% before starting repair to prevent thermal runaway
  • Wear safety glasses to protect eyes from potential flying glass fragments
  • Never use sharp metal tools directly against soft battery pouches

Overview

# Samsung Galaxy Fold 4G Battery Replacement Repair Guide Action-specific battery replacement walkthrough for the Samsung Galaxy Fold 4G. About 64 minutes across 19 steps. This DIY guide walks through battery replacement on the Samsung Galaxy Fold 4G (Galaxy Z series phone). Before you open the device, confirm the exact model number on the Samsung settings screen or rear housing so your replacement part matches the Galaxy Fold 4G specifically—not a similar Galaxy Z sibling. Most DIY techs finish this Samsung Galaxy Fold 4G battery replacement in about 64 minutes when parts and tools are ready. Difficulty is rated intermediate for this model. Recommended tools for this Samsung Galaxy Fold 4G job: Heat gun or hair dryer, Suction cup tool, Plastic prying tools, Precision screwdriver set (Phillips #00), Spudger tool, Tweezers, Anti-static wrist strap. Parts and supplies: Isopropyl alcohol, Battery adhesive removal strips, Pre-cut back cover adhesive gaskets. Power the Galaxy Fold 4G off completely, remove SIMs/SD cards if present, and work on a clean, well-lit surface with a magnetic mat for screws. If a step feels wrong for your Samsung Galaxy Fold 4G, stop and compare the connector layout to the photos in this guide. When you prefer a same-day pro repair in Seattle instead, LML Repair can handle battery replacement for this model with tested parts and a workmanship warranty.

Step-by-step

  1. 1

    Power Down the Device

    1 min

    Press and hold the power button, then tap Power Off on the screen to completely shut down the Galaxy Fold.

  2. 2

    Heat the Rear Glass Panel

    3 min

    Apply a heat gun set to low heat along the edges of the rear glass panel for two minutes to soften the internal adhesive.

  3. 3

    Attach Suction Cup to Rear Glass

    2 min

    Press the suction cup tool near the bottom edge of the rear glass panel and pull upward gently to create a slight gap.

  4. 4

    Slice Rear Glass Adhesive

    5 min

    Insert a plastic prying pick into the gap and slide it slowly along the perimeter to slice through the adhesive seal.

  5. 5

    Remove the Rear Glass Panel

    2 min

    Lift the rear glass cover off the frame carefully and place it on a clean workspace surface.

  6. 6

    Heat the Secondary Back Cover

    3 min

    Apply heat to the outer display side back panel for two minutes to soften its perimeter adhesive.

  7. 7

    Slice and Remove Secondary Back Panel

    5 min

    Insert a plastic prying pick under the secondary back cover, slide around the edges, and lift the panel away.

  8. 8

    Unscrew the Motherboard Bracket

    4 min

    Use a Phillips #00 screwdriver to remove the screws securing the upper wireless charging coil and motherboard bracket.

  9. 9

    Detach Wireless Charging Assembly

    2 min

    Gently lift the plastic wireless charging coil and protective bracket off the motherboard using tweezers.

  10. 10

    Disconnect the Primary Battery

    2 min

    Use the flat end of a plastic spudger to pop the main battery connector straight up off the motherboard socket.

  11. 11

    Unscrew the Lower Speaker Housing

    3 min

    Remove the Phillips #00 screws securing the bottom speaker module and secondary frame guard.

  12. 12

    Disconnect the Secondary Battery

    2 min

    Pry up the secondary battery flex cable connector from its socket using a plastic spudger.

  13. 13

    Soak Primary Battery Adhesive

    3 min

    Apply a few drops of high-concentration isopropyl alcohol around the edges of the primary battery cell and let it sit for two minutes.

  14. 14

    Pry Out the Primary Battery

    5 min

    Insert a wide plastic prying tool beneath the primary battery and carefully lever it out of the chassis recess.

  15. 15

    Soak Secondary Battery Adhesive

    3 min

    Apply isopropyl alcohol around the perimeter of the secondary battery in the opposite housing half.

  16. 16

    Pry Out the Secondary Battery

    5 min

    Lever the secondary battery up using a plastic prying tool until it releases from the frame.

  17. 17

    Install Replacement Batteries

    4 min

    Apply fresh battery adhesive strips into both battery wells, then press the new replacement batteries firmly into position.

  18. 18

    Reconnect Battery Flex Cables

    2 min

    Align and press down both battery connectors into their motherboard sockets until they snap firmly into place.

  19. 19

    Reinstall Brackets and Seal Panels

    8 min

    Reattach the wireless charging coil, speaker module, and secure all Phillips screws before resealing both back glass panels with new adhesive.

After your Samsung Galaxy Fold 4G battery replacement

Power the Galaxy Fold 4G back on and test the battery replacement function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Samsung Galaxy Fold 4G job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.

Prefer a professional repair?

Book Samsung Galaxy Fold 4G battery replacement at LML Repair in Seattle — same-day options available.