Tablet · Apple · iPad Pro 11 5th Gen
Apple iPad Pro 11 5th Gen Speaker Repair
Speaker Repair guide for the Apple iPad Pro 11 5th Gen
Before you begin
Tools
- Heat gun or hair dryer
- Suction cups
- Guitar picks for prying
- Plastic spudger
- Precision screwdriver set
- Tweezers
Parts / materials
- Replacement speaker module
- Pre-cut display adhesive strips
- Isopropyl alcohol (90%+)
- Microfiber cloth
Safety
- Wear safety glasses to protect against potential glass shards.
- Disconnect the battery before handling any internal electronics to prevent short circuits.
- Never use sharp metal tools near the lithium-ion battery.
Overview
Step-by-step
- 1
Power down the iPad
1 minPress and hold the top button and volume button, then slide to turn off the iPad completely.
- 2
Heat the display edges
3 minApply heat evenly along the perimeter of the screen for two minutes using a heat gun to soften the adhesive.
- 3
Attach suction cup to screen
2 minPlace a suction cup on the lower portion of the screen near the home edge and pull upward to create a small gap.
- 4
Slice perimeter display adhesive
5 minInsert a plastic guitar pick into the gap and carefully slide it around all four edges to slice through the adhesive.
- 5
Open display from right edge
2 minGently lift the screen open from the right side like the cover of a book, taking care not to stretch flex cables.
- 6
Unscrew logic board shield plate
2 minUse a precision screwdriver to remove the screws holding the metal display cable cover in place.
- 7
Remove display shield plate
1 minLift the metal shield off the logic board using tweezers and place it aside safely.
- 8
Disconnect the battery cable
1 minUse a plastic spudger to carefully lift the battery connector straight up from its socket on the logic board.
- 9
Disconnect screen flex cables
2 minPry up the display and digitizer press connectors from the logic board to release the screen assembly.
- 10
Remove display assembly
1 minLift the display assembly completely off the frame and set it down on a clean workspace mat.
- 11
Unscrew speaker housing fasteners
3 minRemove the mounting screws securing the lower speaker assembly to the bottom of the aluminum frame.
- 12
Disconnect speaker flex cable
1 minUse a plastic spudger to gently pop the speaker flex cable connector off the logic board socket.
- 13
Pry out speaker assembly
2 minLever a plastic prying tool under the speaker module to break remaining adhesive and lift the speaker out.
- 14
Install replacement speaker module
2 minPosition the new speaker assembly into the lower housing, aligning it carefully with the mounting posts.
- 15
Fasten speaker module screws
2 minReinstall and tighten the screws to securely anchor the replacement speaker in place.
- 16
Plug in speaker flex connector
1 minAlign the speaker flex cable over its logic board socket and press firmly until it clicks into place.
- 17
Reconnect display and battery
4 minSnap display flex cables into their sockets, reconnect the battery cable, and screw down the metal shield plate.
- 18
Reseal and press display frame
3 minApply fresh pre-cut adhesive around the frame, align the screen over the chassis, and press down firmly along the borders.
After your Apple iPad Pro 11 5th Gen speaker repair
Power the iPad Pro 11 5th Gen back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Apple iPad Pro 11 5th Gen job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Apple iPad Pro 11 5th Gen repair context in the encyclopedia, or open related DIY guides.
