Step-by-step

1. 1

   Power Off the Device

   1 min

   Press and hold the power button, then select Power Off on the screen. Ensure the device is fully shut down before proceeding.

2. 2

   Eject the SIM Tray

   1 min

   Insert a SIM eject tool into the small hole on the left side of the frame. Push firmly to eject the tray, then slide it out.

3. 3

   Heat the Back Cover

   3 min

   Apply a heat gun or hair dryer evenly around the edges of the back cover for 2-3 minutes. This softens the adhesive securing the rear panel.

4. 4

   Attach Suction Cup

   1 min

   Press a suction cup firmly near the bottom edge of the back cover. Pull up gently on the suction cup handle to create a small gap.

5. 5

   Slice the Back Cover Adhesive

   4 min

   Insert an opening pick into the gap created by the suction cup. Slide the pick along all four edges to slice through the adhesive tape.

6. 6

   Remove the Back Cover

   2 min

   Lift the rear cover slowly away from the chassis. Set the rear panel aside in a clean, dust-free area.

7. 7

   Unscrew the Midframe

   4 min

   Use a Phillips #00 screwdriver to remove all visible screws securing the plastic midframe panel. Keep track of the screws for reassembly.

8. 8

   Detach the Midframe

   3 min

   Insert a plastic prying tool under the edge of the midframe bezel. Gently pry along the perimeter until all plastic clips unsnap, then lift the midframe off.

9. 9

   Disconnect the Battery Cable

   1 min

   Use the flat end of a spudger to pop the battery flex connector straight up off the motherboard. This prevents electrical short circuits during the repair.

10. 10

    Disconnect the Display Cable

    1 min

    Locate the display ribbon cable on the lower section of the main board. Use a spudger to carefully unplug the connector from its socket.

11. 11

    Remove the Battery

    4 min

    Pull the clear adhesive release tabs located on the sides of the battery. Slowly lift the battery out of the housing without puncturing it.

12. 12

    Heat the Display Frame

    3 min

    Use your heat gun to heat the perimeter of the front screen for 2-3 minutes. This softens the screen perimeter adhesive holding the display panel.

13. 13

    Separate the Damaged Screen

    5 min

    Place a suction cup on the front glass and pull upward while inserting a thin plastic pick. Slide the pick around the edges to separate the cracked screen from the frame.

14. 14

    Clean Residual Adhesive

    4 min

    Scrape off old adhesive strips from the frame using a spudger and tweezers. Wipe down the inner seating ledge with isopropyl alcohol.

15. 15

    Test the New Screen

    4 min

    Temporarily connect the replacement screen cable and battery to the motherboard. Power on the phone briefly to verify display image and touch responsiveness.

16. 16

    Apply Screen Adhesive

    3 min

    Lay fresh, double-sided adhesive strips along the perimeter frame where the screen rests. Peel away the protective backing film from the adhesive.

17. 17

    Install the New Screen

    3 min

    Thread the display flex cable through the slot in the frame. Gently press the new screen into position, ensuring it sits flush within the housing.

18. 18

    Reassemble Internal Components

    4 min

    Reinstall the battery, reconnect the display and battery flex cables, snap the midframe into place, and secure all Phillips screws.

19. 19

    Reseal the Back Cover

    3 min

    Apply fresh back cover adhesive around the frame edge. Press the back cover firmly onto the phone for 1-2 minutes to secure the bond.