Skip to main content
logo

Phone · Motorola · G60

Motorola G60 Speaker Repair

Speaker Repair guide for the Motorola G60

Moderate
~29 min
13 steps

Before you begin

Tools

  • Phillips #00 screwdriver
  • Heat gun or hair dryer
  • Suction cup tool
  • Plastic opening picks
  • Spudger tool
  • Tweezers
  • SIM eject tool

Parts / materials

  • Replacement Motorola G60 loudspeaker
  • Pre-cut rear cover adhesive tape
  • Isopropyl alcohol (91%+)

Safety

  • Power off the device before beginning repair to prevent electrical short circuits.
  • Do not heat the phone beyond 80°C (176°F) to protect the internal battery.
  • Use caution when lifting the back cover to avoid tearing the delicate fingerprint sensor ribbon cable.

Overview

# Motorola G60 Speaker Repair Repair Guide Action-specific speaker repair walkthrough for the Motorola G60. About 29 minutes across 13 steps. This DIY guide walks through speaker repair on the Motorola G60 (Moto G series phone). Before you open the device, confirm the exact model number on the Motorola settings screen or rear housing so your replacement part matches the G60 specifically—not a similar Moto G sibling. Most DIY techs finish this Motorola G60 speaker repair in about 29 minutes when parts and tools are ready. Difficulty is rated intermediate for this model. Recommended tools for this Motorola G60 job: Phillips #00 screwdriver, Heat gun or hair dryer, Suction cup tool, Plastic opening picks, Spudger tool, Tweezers, SIM eject tool. Parts and supplies: Replacement Motorola G60 loudspeaker, Pre-cut rear cover adhesive tape, Isopropyl alcohol (91%+). Power the G60 off completely, remove SIMs/SD cards if present, and work on a clean, well-lit surface with a magnetic mat for screws. If a step feels wrong for your Motorola G60, stop and compare the connector layout to the photos in this guide. When you prefer a same-day pro repair in Seattle instead, LML Repair can handle speaker repair for this model with tested parts and a workmanship warranty.

Step-by-step

  1. 1

    Power off phone

    1 min

    Turn off your Motorola Moto G60 completely before beginning disassembly.

  2. 2

    Remove SIM tray

    1 min

    Insert a SIM eject tool into the SIM tray hole to eject and remove the card tray.

  3. 3

    Heat rear cover

    2 min

    Apply heat around the edges of the rear cover for two minutes to soften the adhesive.

  4. 4

    Slice adhesive

    3 min

    Attach a suction cup to the lower back cover, pull up gently, and insert a plastic opening pick into the gap.

  5. 5

    Unclip back cover

    4 min

    Slide the pick along the outer perimeter to slice remaining adhesive and unlatch the plastic clips.

  6. 6

    Disconnect fingerprint cable

    2 min

    Lift the rear cover slightly from the right side and use a spudger to detach the fingerprint sensor flex cable.

  7. 7

    Remove Phillips screws

    3 min

    Remove the seven Phillips #00 screws securing the bottom loudspeaker housing to the phone frame.

  8. 8

    Pry out loudspeaker

    2 min

    Insert a plastic spudger under the notch of the loudspeaker module and gently pry it up.

  9. 9

    Set replacement loudspeaker

    2 min

    Place the new loudspeaker assembly into the frame cavity and press it flat into position.

  10. 10

    Secure loudspeaker screws

    3 min

    Reinstall the seven Phillips #00 screws to firmly lock the loudspeaker module in place.

  11. 11

    Reconnect fingerprint cable

    2 min

    Align and press the fingerprint sensor flex cable connector onto its motherboard socket until it clicks.

  12. 12

    Reattach back cover

    3 min

    Apply new perimeter adhesive to the frame and press the rear cover back on along all edges.

  13. 13

    Reinsert SIM tray

    1 min

    Slide the SIM card tray back into its slot until flush with the outer frame.

After your Motorola G60 speaker repair

Power the G60 back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola G60 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.

Keep learning

Explore more Motorola G60 repair context in the encyclopedia, or open related DIY guides.

Repair encyclopediaAll G60 guides
logo_footer

Stay in the loop

Get new guides, reviews, and repair news.

Quick Links

Explore

    © 2026 LML Repair. All rights reserved.