Phone · Motorola · Moto E20
Motorola Moto E20 Speaker Repair
Speaker Repair guide for the Motorola Moto E20
Before you begin
Tools
- Phillips #000 Screwdriver
- SIM Card Eject Tool
- Plastic Opening Picks
- Spudger Tool
- Precision Tweezers
- Anti-static wrist strap
Parts / materials
- Replacement Moto E20 loudspeaker module
- Isopropyl alcohol (90%+)
Safety
- Power off the phone completely before beginning any physical teardown.
- Do not puncture or bend the internal lithium-ion battery during disassembly.
- Wear safety glasses to protect against small plastic clip debris.
Overview
Step-by-step
- 1
Power down the device
1 minPress and hold the power button, then select Power Off on the screen.
- 2
Remove the SIM tray
1 minInsert a SIM eject tool into the pinhole on the left side of the frame and push firmly to pop out the tray.
- 3
Unclip the back cover
2 minInsert a plastic opening pick into the seam between the display assembly and back cover near the SIM slot.
- 4
Release perimeter clips
3 minSlide the pick around all four edges of the phone to unlatch the plastic retaining clips.
- 5
Disconnect fingerprint sensor
2 minTilt the rear cover open slightly and use a spudger to pop the fingerprint sensor ribbon cable off the motherboard.
- 6
Remove the rear cover
1 minLift the rear cover completely away from the phone body and place it on your workspace.
- 7
Unscrew the speaker housing
3 minUse a Phillips #000 screwdriver to remove the six screws securing the bottom loudspeaker cover.
- 8
Pry up the speaker module
2 minInsert the flat tip of a spudger under the notch of the speaker housing and gently pry it upward.
- 9
Remove the speaker module
1 minLift the damaged speaker assembly straight out of the phone chassis.
- 10
Clean the speaker recess
1 minInspect the lower housing for debris or dust build-up and clean it using precision tweezers or compressed air.
- 11
Position the replacement speaker
2 minAlign the new loudspeaker module into the lower cavity of the frame and press it gently into place.
- 12
Secure the speaker screws
3 minReinstall and tighten the six Phillips #000 screws to hold the loudspeaker assembly firmly.
- 13
Reconnect fingerprint flex cable
2 minHold the back cover near the chassis and press the fingerprint sensor cable connector straight onto its motherboard socket.
- 14
Snap on the rear cover
2 minAlign the back cover with the phone body and squeeze along the edges until all clips click shut.
- 15
Reinsert the SIM tray
1 minPush the SIM card tray back into its slot on the side of the device until it sits flush.
After your Motorola Moto E20 speaker repair
Power the Moto E20 back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto E20 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto E20 repair context in the encyclopedia, or open related DIY guides.
