Step-by-step

1. 1

   Power Off the Tablet

   1 min

   Press and hold the power button, then select Power Off on the screen. Ensure the device is completely powered down before beginning.

2. 2

   Heat Display Edges

   3 min

   Apply a heated iOpener or heat gun around the screen perimeters for 2 to 3 minutes. This softens the strong adhesive holding the display to the frame.

3. 3

   Attach Suction Handle

   2 min

   Place a suction cup near the top edge of the screen and press firmly. Pull up gently on the suction cup to create a small gap between the glass and the bezel.

4. 4

   Slice Display Adhesive

   5 min

   Insert a plastic opening pick into the gap created by the suction cup. Slowly slide the pick around all four edges to slice through the display adhesive.

5. 5

   Pry Open Display Assembly

   2 min

   Carefully tilt the screen open from the left edge like a book cover. Do not pull the screen away entirely yet, as fragile flex cables are still connected.

6. 6

   Disconnect Display Flex Cable

   3 min

   Use a plastic spudger to pry up the metal bracket shield covering the display connector. Pry the display flex cable straight up from its motherboard socket and remove the screen.

7. 7

   Unscrew Motherboard Shield

   3 min

   Use a Phillips screwdriver to remove the small screws holding the protective metal bracket over the upper motherboard section.

8. 8

   Remove Shield Bracket

   2 min

   Use precision tweezers to lift and remove the metal shield bracket. Store the screws safely for reassembly.

9. 9

   Disconnect Fingerprint Cable

   2 min

   Locate the power button and fingerprint sensor flex cable connection near the side frame. Use a plastic spudger to pop the press-fit connector off the board.

10. 10

    Remove Fingerprint Sensor Assembly

    3 min

    Use tweezers to unclip the holding bracket and gently pry the fingerprint sensor module out of its recessed slot in the frame.

11. 11

    Insert Replacement Fingerprint Sensor

    2 min

    Align the new fingerprint sensor button module into the frame slot. Press gently until it sits flush against the outer chassis.

12. 12

    Connect Sensor Cable

    2 min

    Align the press-fit connector on the new sensor's ribbon cable over its motherboard socket. Press down firmly until it clicks into place.

13. 13

    Reattach Shield Bracket

    3 min

    Position the metal upper shield bracket back over the motherboard connectors. Secure it in place using the Phillips screws removed earlier.

14. 14

    Reconnect Display Assembly

    3 min

    Snap the display flex cable back onto its motherboard connector. Replace the cable bracket to secure the connection.

15. 15

    Apply Screen Adhesive

    4 min

    Clean remaining old adhesive off the frame using isopropyl alcohol, then lay down pre-cut adhesive strips along the inner frame perimeter.

16. 16

    Seal Display Glass

    2 min

    Align the screen perfectly with the tablet body and lower it into place. Apply firm, uniform pressure around all edges to bond the adhesive.