Tablet · Microsoft · Surface Go
Power Button Repair Guide for Surface Go
Power Button Repair guide for the Microsoft Surface Go
Before you begin
Tools
- Heat gun or hair dryer
- Suction cup
- Guitar picks for prying
- Precision screwdriver set
- Spudger
- Tweezers
- Plastic prying tools
Parts / materials
- Replacement power button flex cable
- Pre-cut screen adhesive strips
- Isopropyl alcohol (99%)
Safety
- Wear safety glasses to protect against potential glass splinters.
- Always disconnect the battery before working near internal circuitry.
- Do not overheat the screen to avoid damaging the underlying LCD panel.
Overview
Step-by-step
- 1
Power Down Device
1 minTurn off the Surface Go completely and disconnect all attached cables and micro-SD cards.
- 2
Heat Screen Edges
3 minApply heat evenly around the perimeter of the screen for two to three minutes to soften the adhesive.
- 3
Attach Suction Cup
2 minPlace a suction cup near the top edge of the display and pull gently upward to create a small gap.
- 4
Insert Opening Pick
2 minSlide a plastic guitar pick into the gap between the glass screen and the outer frame.
- 5
Slice Screen Adhesive
5 minSlice carefully around all four display edges using picks to fully separate the adhesive.
- 6
Lift Display Assembly
2 minGently hinge the glass screen upward from the top edge to expose internal components.
- 7
Remove Connector Shield
3 minUnscrew the Torx screws securing the metal shield over the display connector and lift the shield off.
- 8
Disconnect Display Cable
2 minUse a plastic spudger to pry the display connector straight up off the motherboard.
- 9
Disconnect Battery Connector
2 minDisconnect the main battery flex cable from the motherboard to cut power before proceeding.
- 10
Unscrew Button Bracket
3 minRemove the T3 Torx screws securing the metal power button bracket to the chassis frame.
- 11
Disconnect Button Cable
2 minPry the power button flex cable connector off its motherboard socket using a spudger.
- 12
Peel Button Assembly
2 minGently peel the damaged power button flex cable and switch module out of the chassis.
- 13
Position New Flex Cable
2 minAlign the replacement power button flex assembly into the chassis channel and press it down.
- 14
Secure Button Bracket
3 minReinstall the metal bracket over the power button and tighten the screws firmly.
- 15
Reconnect Internal Cables
4 minPlug the power button flex, battery, and display cables back into their motherboard sockets.
- 16
Seal Display Assembly
5 minApply new adhesive strips along the frame, align the screen, and press firmly along the perimeter.
After your Microsoft Surface Go power button repair
Power the Surface Go back on and test the power button repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Microsoft Surface Go job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Microsoft Surface Go repair context in the encyclopedia, or open related DIY guides.
