Tablet · Microsoft · Surface Go 2
Microsoft Surface Go 2 Speaker Repair
Speaker Repair guide for the Microsoft Surface Go 2
Before you begin
Tools
- Heat gun or hair dryer
- Suction cup
- Guitar picks for prying
- Plastic spudger
- Precision T3 Torx screwdriver
- Tweezers
- Anti-static wrist strap
Parts / materials
- Replacement left and right speaker modules
- Pre-cut display adhesive strips
- Isopropyl alcohol (90%+)
Safety
- Wear safety glasses while heating and prying glass components.
- Do not insert prying tools deeper than 3mm to prevent damaging delicate ribbons.
- Disconnect battery or screen flex connectors promptly before touching internal circuitry.
Overview
Step-by-step
- 1
Power down the Surface Go 2
1 minTurn off your device completely and disconnect any charging cables or external peripherals.
- 2
Heat the display edges
3 minUse a heat gun or hair dryer around the outer glass perimeter for two minutes to soften the frame adhesive.
- 3
Attach the suction cup
2 minPlace a suction cup near the top center of the glass screen and pull upward gently to create a seam.
- 4
Insert an opening pick
2 minSlide a thin guitar pick into the slight gap between the glass screen and the aluminum body.
- 5
Slice the screen adhesive
5 minCarefully slide opening picks along all four edges of the tablet, keeping depth under 3mm to protect internal flex cables.
- 6
Lift the display assembly
2 minGently tilt the display open from the right side like a book cover, keeping cable tension low.
- 7
Unscrew the display connector shield
3 minUse a precision T3 Torx screwdriver to remove the screws securing the metal shield over the display cable connector.
- 8
Detach the display flex cables
2 minUse a plastic spudger to pry the display connector straight up from the motherboard and set the screen aside.
- 9
Unplug the speaker connectors
2 minLocate the left and right speaker cable headers on the motherboard and disconnect them with a spudger.
- 10
Remove the speaker mounting screws
3 minRemove the T3 Torx screws holding both speaker modules down to the tablet frame.
- 11
Pry out the damaged speakers
2 minInsert a plastic prying tool beneath each speaker module and lift them out of their frame recesses.
- 12
Seat the new speakers
3 minPlace the replacement left and right speakers into their housing slots and secure them with the T3 screws.
- 13
Plug in the speaker cables
2 minPress the speaker wiring harness connectors firmly onto their corresponding motherboard sockets.
- 14
Reconnect the display assembly
4 minAlign and press the display flex connector onto the motherboard, then reinstall the metal shield and screws.
- 15
Apply fresh adhesive and seal
5 minClean off old glue, lay new pre-cut adhesive strips along the frame perimeter, and press the glass screen firmly into place.
After your Microsoft Surface Go 2 speaker repair
Power the Surface Go 2 back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Microsoft Surface Go 2 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Microsoft Surface Go 2 repair context in the encyclopedia, or open related DIY guides.
