Tablet · Microsoft · Surface 2
Microsoft Surface 2 Home Button Repair
Home Button Repair guide for the Microsoft Surface 2
Before you begin
Tools
- Precision screwdriver set
- Plastic opening tools
- Anti-static wrist strap
- Tweezers
- Heat gun or iOpener
- Opening picks
- Spudger
Parts / materials
- Replacement Surface 2 home button flex cable
- Pre-cut display adhesive strips
- Isopropyl alcohol (99%)
Safety
- Power down the tablet completely before beginning disassembly.
- Wear safety glasses while heating glass to guard against potential cracking or shattering.
- Avoid applying direct heat to the internal battery to prevent thermal hazards.
Overview
Step-by-step
- 1
Ground yourself with an anti-static strap
2 minAttach the anti-static wrist strap to a grounded metal object to prevent ESD damage to internal components.
- 2
Heat the screen edges
5 minApply heat around the outer glass border using a heat gun set to low to soften the factory adhesive.
- 3
Insert an opening pick
3 minCarefully slide a thin plastic opening pick into the seam between the glass screen and the magnesium outer frame.
- 4
Slice the perimeter adhesive
6 minSlowly slide the pick along all four edges of the screen to cut through the remaining adhesive tape.
- 5
Lift the display assembly
3 minGently lift the top edge of the display glass, taking care not to strain the delicate flex cables connected at the bottom.
- 6
Unscrew the connector shield
4 minUse a T5 Torx screwdriver to remove the small screws holding the metal bracket over the display cable connectors.
- 7
Disconnect the display cables
3 minUse a plastic spudger to gently pry the display and digitizer press connectors off the motherboard.
- 8
Disconnect the home button ribbon
2 minLocate the small home button flex connector at the bottom frame edge and pop it free using tweezers or a spudger.
- 9
Peel off the home button assembly
3 minUse fine-tip tweezers to carefully lift the capacitive home button sensor pad and ribbon cable off the lower bezel.
- 10
Align the new home button ribbon
3 minPlace the replacement home button sensor onto the bottom bezel, ensuring perfect alignment with the glass home logo.
- 11
Apply fresh frame adhesive
5 minClean off old glue residue with isopropyl alcohol, then stick double-sided adhesive strips along the inner chassis rim.
- 12
Reconnect the flex cables
4 minSnap the home button cable and main display cables back onto their motherboard sockets, then reinstall the metal shield.
- 13
Seal the screen assembly
3 minAlign the glass display over the chassis and press firmly around all edges to secure it in place.
After your Microsoft Surface 2 home button repair
Power the Surface 2 back on and test the home button repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Microsoft Surface 2 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Microsoft Surface 2 repair context in the encyclopedia, or open related DIY guides.
