Tablet · Microsoft · Surface Pro 6
Microsoft Surface Pro 6 Home Button Repair
Home Button Repair guide for the Microsoft Surface Pro 6
Before you begin
Tools
- Precision screwdriver set
- Plastic opening tools
- Anti-static wrist strap
- Tweezers
- Suction cup
- Heat gun or iOpener
- Spudger
Parts / materials
- Replacement button flex cable assembly
- Precut display adhesive strips
- 90%+ Isopropyl alcohol
- Lint-free cleaning wipes
Safety
- Wear protective eye gear when heating glass to guard against potential breakage.
- Do not insert prying picks deeper than 4mm to prevent tearing hidden flex cables.
- Disconnect or isolate battery power before touching internal electronics.
Overview
Step-by-step
- 1
Power down device
1 minCompletely turn off your Surface Pro 6 and disconnect all external cables and memory cards.
- 2
Heat display perimeter
4 minApply a heated pad or heat gun around the outer edges of the glass screen to soften the underlying adhesive.
- 3
Attach suction cup
2 minPlace a suction cup near the top edge of the display and pull upward to create a slight gap.
- 4
Insert opening pick
2 minSlide a thin plastic opening pick into the gap between the glass screen and the magnesium frame.
- 5
Slice screen adhesive
6 minCarefully slide opening picks along all four edges, keeping inserts under 4mm to avoid damaging internal flex cables.
- 6
Open screen assembly
2 minGently swing the display panel open from the right edge like a book page.
- 7
Remove display connector shield
3 minUnscrew the Torx screws securing the metal shield over the display connectors using a precision screwdriver.
- 8
Disconnect display cables
2 minUse a plastic spudger to pop the display ribbon cables directly off their motherboard sockets.
- 9
Isolate battery power
2 minInsert a plastic guitar pick beneath the battery connector contacts to cut power during the repair.
- 10
Unscrew button bracket
3 minRemove the small Torx screws securing the power and volume button assembly bracket to the upper frame.
- 11
Disconnect button flex cable
2 minPry up the press-fit button flex cable connector from the top edge of the motherboard.
- 12
Remove damaged button flex
2 minPeel the damaged button flex cable away from the internal chassis using fine tweezers.
- 13
Position new button assembly
3 minAlign the replacement button flex module into the frame cutouts and press the tactile switches into place.
- 14
Connect button flex cable
2 minSnap the button flex cable connector firmly onto its motherboard socket.
- 15
Reinstall button bracket
2 minPlace the metal retaining bracket over the button module and tighten the securing Torx screws.
- 16
Clean old adhesive
5 minScrape remaining adhesive off the frame border using isopropyl alcohol and a plastic tool.
- 17
Apply display adhesive strips
4 minLay fresh, precut double-sided adhesive tape along the full perimeter of the frame.
- 18
Reconnect display assembly
3 minAttach the screen flex cables to the motherboard and screw the protective metal shield back in place.
- 19
Seal screen panel
3 minAlign the display glass with the frame and press firmly around all four edges to set the new bond.
After your Microsoft Surface Pro 6 home button repair
Power the Surface Pro 6 back on and test the home button repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Microsoft Surface Pro 6 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Microsoft Surface Pro 6 repair context in the encyclopedia, or open related DIY guides.
