Tablet · Microsoft · Surface Pro 2
Microsoft Surface Pro 2 Home Button Repair
Home Button Repair guide for the Microsoft Surface Pro 2
Before you begin
Tools
- Precision screwdriver set
- Plastic opening picks
- Suction cup
- Heat gun or iOpener
- Tweezers
- Spudger
- Anti-static wrist strap
Parts / materials
- Surface Pro 2 home button flex cable
- Pre-cut screen adhesive tape
- 99% Isopropyl alcohol
Safety
- Wear safety glasses to protect against potential glass fragments during screen removal.
- Ensure the tablet is completely powered off and unplugged before opening.
- Avoid applying excessive heat to prevent thermal damage to internal components.
Overview
Step-by-step
- 1
Power off the tablet
2 minShut down your Surface Pro 2 completely and disconnect all attached cables and power adapters. Put on an anti-static wrist strap.
- 2
Heat the screen edges
3 minUse a heat gun or heating pad around the perimeter glass for two minutes to soften the strong frame adhesive.
- 3
Attach a suction cup
2 minPress a heavy-duty suction cup onto the upper edge of the display glass and pull upward gently to create a seam.
- 4
Insert an opening pick
2 minSlide a thin plastic opening pick into the gap between the glass edge and the outer magnesium frame.
- 5
Slice the perimeter adhesive
8 minSlide opening picks continuously around all four edges of the tablet to break the remaining adhesive bond.
- 6
Lift the display assembly
3 minGently tilt the glass assembly up from the right side, taking care not to strain the internal ribbon cables.
- 7
Disconnect the display cables
3 minUse a spudger to carefully unclip the display press connector and digitizer ribbon cable from the motherboard.
- 8
Remove the display assembly
2 minLift the display panel completely clear of the tablet chassis and place it face-down on a soft surface.
- 9
Locate the home button flex cable
2 minFind the capacitive Windows home button ribbon cable positioned near the bottom center of the frame assembly.
- 10
Unlatch the home button ZIF socket
2 minUse the tip of a spudger or tweezers to flip up the small black retaining flap on the ZIF socket.
- 11
Remove the damaged flex cable
3 minPeel the original home button ribbon cable away from the frame adhesive and pull it out of the socket with tweezers.
- 12
Install the new home button cable
3 minAlign the replacement home button flex cable into position against the lower inner bezel.
- 13
Lock the ZIF connector
2 minInsert the flex cable tip fully into the motherboard socket and press down the locking flap to hold it securely.
- 14
Reattach display cables
3 minAlign and press down the display and digitizer ribbon connectors onto their motherboard sockets until they click.
- 15
Apply fresh adhesive strips
5 minClean the frame borders with isopropyl alcohol and lay down fresh pre-cut adhesive tape along all four perimeter edges.
- 16
Seal the screen assembly
3 minAlign the display glass over the magnesium frame and press firmly along the borders to seal it in place.
After your Microsoft Surface Pro 2 home button repair
Power the Surface Pro 2 back on and test the home button repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Microsoft Surface Pro 2 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Microsoft Surface Pro 2 repair context in the encyclopedia, or open related DIY guides.
