Step-by-step

1. 1

   Power Down iPad

   1 min

   Press and hold the top button and either volume button, then slide to power off. Ensure the screen is completely black before proceeding.

2. 2

   Heat Front Glass Edges

   3 min

   Apply heat around the edges of the screen for two minutes using a heat gun set to low heat. Keep the heat moving continuously to prevent glass or display damage.

3. 3

   Attach Suction Handle

   2 min

   Place a suction cup onto the upper portion of the glass screen near the front camera. Pull upward with steady force to create a tiny gap along the perimeter seam.

4. 4

   Insert Opening Pick

   2 min

   Slide a thin guitar pick into the seam created between the glass display and the outer aluminum body. Do not insert the pick deeper than 3 mm to protect internal display flexes.

5. 5

   Slice Screen Adhesive

   5 min

   Slide the guitar pick carefully around all four display borders to cut through the perimeter adhesive. Place additional picks in the corners to keep the adhesive from sticking again.

6. 6

   Open Screen Assembly

   2 min

   Gently lift the left edge of the display and pivot it open toward the right like a book cover. Support the screen against a solid object so it does not pull on fragile cables.

7. 7

   Unscrew Display Shield

   3 min

   Remove the screws holding the metal display connector shield to the logic board with a precision screwdriver. Store the screws in a organized tray.

8. 8

   Remove Connector Shield

   1 min

   Lift the metal display shield up and off the logic board using tweezers or plastic prying tools. Place it aside safely for reassembly.

9. 9

   Disconnect Battery Flex

   2 min

   Insert a plastic spudger under the battery connector and lift it straight up to disconnect battery power. Keep metal tools away from the logic board to avoid electrical shorts.

10. 10

    Disconnect Screen Cables

    2 min

    Pry the display flex cable connectors straight up from their logic board sockets. Move the freed screen assembly to a clean, soft surface.

11. 11

    Unscrew Port Bracket

    2 min

    Remove the small metal bracket covering the USB-C charging port flex cable connector near the bottom edge. Set the bracket and screw aside.

12. 12

    Disconnect Port Connector

    1 min

    Pry the USB-C port flex cable connector straight off its board socket using a plastic prying tool. Take care not to scrape neighboring board chips.

13. 13

    Unscrew Charging Port

    2 min

    Remove the mounting screws securing the USB-C charging port housing to the lower frame. Keep these screws separate from display bracket hardware.

14. 14

    Remove Old Port

    2 min

    Pry the damaged USB-C port assembly out of the lower aluminum housing using a plastic spudger. Lift the unit clear of the iPad body.

15. 15

    Install New Port

    3 min

    Seat the replacement USB-C charging port assembly into the housing cutout at the bottom of the device frame. Reinstall and tighten the mounting screws securely.

16. 16

    Connect Port Cable

    2 min

    Align the flex connector over its logic board socket and press down gently until it clicks into place. Reattach the protective metal bracket over the connector.

17. 17

    Reconnect Screen and Battery

    4 min

    Snap the display flex cables and battery connector back onto the board, then reinstall the main screen bracket. Power on the device to test charging function before final sealing.