Tablet · Apple · iPad Air 2
Apple iPad Air 2 Speaker Repair
Speaker Repair guide for the Apple iPad Air 2
Before you begin
Tools
- Heat gun or hair dryer
- Suction cups
- Guitar picks for prying
- Plastic prying tools
- Precision screwdriver set
- Anti-static wrist strap
Parts / materials
- Replacement iPad Air 2 speakers
- Pre-cut display adhesive strips
- Isopropyl alcohol (90%+)
Safety
- Wear eye protection to guard against potential glass shards if the screen is cracked.
- Keep heat tools away from skin and flammable surfaces.
- Avoid using sharp metal tools directly near the lithium-ion battery.
Overview
Step-by-step
- 1
Heat the Front Assembly
3 minUse a heat gun or hair dryer around the outer edges of the front glass for two minutes to soften the perimeter adhesive.
- 2
Attach Suction Cup
1 minPlace a suction cup on the lower portion of the screen, taking care not to place it directly over the Home button.
- 3
Insert Opening Pick
2 minPull up firmly on the suction cup to create a small gap, then slide a plastic guitar pick under the glass.
- 4
Slice Perimeter Adhesive
5 minSlide the pick carefully around the edges to cut through the adhesive, keeping the pick shallow near the top right flex cables.
- 5
Pivot the Display Open
2 minGently lift the top edge of the screen assembly up and open it like a book to access the logic board shield.
- 6
Remove Display Shield Screws
3 minUnscrew the four Phillips #00 screws holding the metal display cable shield in place.
- 7
Remove Display Cable Shield
1 minLift the metal shield off the logic board using tweezers or plastic prying tools and set it aside.
- 8
Disconnect Display Flex Cables
2 minUse the flat end of a plastic spudger to pry the three display flex cable connectors straight up from their sockets.
- 9
Separate Display Assembly
1 minLift the display assembly completely off the rear enclosure and place it in a safe, clean area.
- 10
Remove Speaker Bracket Screws
3 minUnscrew the Phillips screws securing the left and right speaker modules to the bottom of the enclosure.
- 11
Warm Lower Rear Case
2 minApply heat briefly to the lower rear aluminium casing to loosen the adhesive securing the speakers.
- 12
Pry Out Faulty Speakers
3 minInsert a plastic spudger beneath each speaker module and carefully pry them up from the housing.
- 13
Install Replacement Speakers
3 minAlign the new speaker modules into the bottom housing and press down firmly to set the adhesive.
- 14
Secure Speaker Screws
2 minThread and tighten the Phillips screws to hold the new speakers firmly against the chassis.
After your Apple iPad Air 2 speaker repair
Power the iPad Air 2 back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Apple iPad Air 2 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Apple iPad Air 2 repair context in the encyclopedia, or open related DIY guides.
