Tablet · Apple · iPad Air 13
Apple iPad Air 13 Apple Pencil Port Repair
Apple Pencil Port Repair guide for the Apple iPad Air 13
Before you begin
Tools
- Heat gun or hair dryer
- Suction cups
- Guitar picks for prying
- Plastic prying tools
- Precision screwdriver set
- Tweezers
- Spudger
Parts / materials
- Replacement Apple Pencil charging module
- Pre-cut display adhesive strips
- 99% Isopropyl alcohol
Safety
- Wear eye protection when prying bonded glass panels.
- Disconnect the battery before touching logic board components to prevent short circuits.
- Do not bend or puncture the battery cell inside the enclosure.
Overview
Step-by-step
- 1
Heat the display edges
3 minApply a heat gun or hair dryer around the perimeter of the front glass for two minutes. This softens the adhesive securing the display to the frame.
- 2
Attach suction cup
2 minPlace a suction cup near the top edge of the front glass. Pull upward firmly to create a small gap between the glass and the aluminum enclosure.
- 3
Insert opening pick
2 minSlide a plastic opening pick into the gap created by the suction cup. Keep the pick shallow to avoid damaging internal component ribbons.
- 4
Slice perimeter adhesive
5 minSlide the pick carefully around all four sides of the iPad to cut through the adhesive seal. Insert additional picks in the corners to prevent re-sealing.
- 5
Open display assembly
2 minGently lift the top edge of the display and pivot it open towards the right edge like a book. Do not separate the screen completely yet.
- 6
Unscrew logic board shield
3 minRemove the retaining screws securing the metal shield over the logic board connectors using a precision screwdriver. Set the shield aside.
- 7
Disconnect battery cable
2 minUse the flat end of a plastic spudger to lift the battery connector straight off the logic board. This cuts power to prevent electrical damage.
- 8
Disconnect display cables
3 minPry up the display press connectors from the logic board with a spudger. Fully remove the display assembly and store it in a safe place.
- 9
Unscrew Pencil charger bracket
3 minLocate the magnetic Pencil charging module along the internal side rail. Remove the screws securing its protective metal bracket.
- 10
Disconnect Pencil charger flex
2 minUse a spudger to gently pop the Pencil charger flex cable connector off its logic board socket.
- 11
Pry out charging pad
2 minInsert a plastic spudger beneath the magnetic charging pad and pry it off the interior frame wall. Remove the failed module.
- 12
Install new charging module
2 minAlign the replacement Apple Pencil charging module flush against the side rail slot. Press firmly to engage any adhesive backing.
- 13
Secure charger and reconnect
5 minAttach the flex cable connector to the logic board and reinstall the metal bracket with its screws. Reconnect the display and battery before closing.
After your Apple iPad Air 13 apple pencil port repair
Power the iPad Air 13 back on and test the apple pencil port repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Apple iPad Air 13 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Apple iPad Air 13 repair context in the encyclopedia, or open related DIY guides.
