Step-by-step

1. 1

   Heat the Screen Edges

   3 min

   Apply a heated iOpener or heat gun around the front display perimeter for two minutes to soften the frame adhesive.

2. 2

   Attach Suction Cup

   1 min

   Place a suction cup near the top center edge of the glass display and press down firmly to secure a tight grip.

3. 3

   Create an Opening Gap

   2 min

   Pull up gently on the suction cup handle to lift the glass slightly away from the chassis, then slide an opening pick beneath the seam.

4. 4

   Slice Left Edge Adhesive

   3 min

   Slide the opening pick down the left bezel to cut through the adhesive, keeping insertion depth under 3 mm to avoid internal components.

5. 5

   Slice Right Edge Adhesive

   3 min

   Glide the pick along the right side edge, using caution around the display cable routing area.

6. 6

   Separate Bottom Edge Adhesive

   3 min

   Carefully slice through the adhesive along the bottom bezel, ensuring the pick remains shallow.

7. 7

   Prop Open the Display

   2 min

   Lift the display open from the left edge like a book cover to access the interior components.

8. 8

   Remove Bracket Screws

   2 min

   Use a Phillips #000 screwdriver to remove the screws securing the metal display cable bracket.

9. 9

   Remove Display Shield

   1 min

   Use precision tweezers to lift and remove the metal cable bracket from the logic board.

10. 10

    Isolate the Battery

    2 min

    Insert a plastic battery blocker pick beneath the battery contact screw pad to disconnect power.

11. 11

    Disconnect Display Connectors

    2 min

    Use a spudger to gently pop the display flex connectors straight up from their sockets on the logic board.

12. 12

    Detach Display Assembly

    1 min

    Lift the entire display assembly away from the rear enclosure and place it flat on a clean surface.

13. 13

    Apply Adhesive Remover

    2 min

    Apply a few drops of high-purity isopropyl alcohol around the outer edges of the battery cells.

14. 14

    Heat the Rear Case

    3 min

    Turn the iPad over and apply heat across the rear shell directly behind the battery for two minutes to loosen the glue.

15. 15

    Pry Out Old Battery

    6 min

    Slide a plastic opening card under the battery cells and slowly lever upward until the adhesive releases.

16. 16

    Clean Enclosure Residuals

    4 min

    Scrape remaining adhesive off the aluminum casing using a spudger soaked with isopropyl alcohol.

17. 17

    Apply Battery Adhesive Strips

    3 min

    Peel the backing off new battery adhesive strips and apply them firmly to the underside of the replacement battery.

18. 18

    Install Replacement Battery

    3 min

    Align the replacement battery into the aluminum chassis and press down firmly along the cells to seat the adhesive.

19. 19

    Reconnect Display Cables

    2 min

    Position the display assembly near the frame and press the flex cable connectors back onto the logic board until they snap.

20. 20

    Reinstall Metal Shield

    2 min

    Place the display bracket back over the cable connectors and tighten the securing Phillips screws.

21. 21

    Apply Bezel Adhesive

    4 min

    Lay fresh perimeter adhesive strips along the edges of the aluminum rear housing.

22. 22

    Seal Display Assembly

    3 min

    Lower the glass display back into alignment with the frame and press firmly along all edges to set the seal.