Tablet · Apple · iPad 5
Apple iPad 5 Speaker Repair
Speaker Repair guide for the Apple iPad 5
Before you begin
Tools
- Heat gun or iOpener
- Suction cup
- Plastic opening picks
- Phillips #00 screwdriver
- Spudger
- Tweezers
- Plastic card
Parts / materials
- Replacement speaker modules
- Pre-cut digitizer adhesive strips
- Isopropyl alcohol (91%+)
Safety
- Wear eye protection when heating glass to avoid injury from potential fractures.
- Wear an anti-static wrist strap to protect sensitive logic board components.
- Do not bend or puncture the lithium-ion battery located under the LCD.
Overview
Step-by-step
- 1
Heat perimeter glass
3 minUse a heat gun or iOpener along the front edges of the iPad for two minutes to soften the display adhesive.
- 2
Attach suction cup
2 minPlace a suction cup on the upper left corner of the glass and gently pull up to create a small opening gap.
- 3
Slice front glass adhesive
5 minInsert a plastic opening pick into the gap and carefully slide it around the perimeter to sever the adhesive.
- 4
Open digitizer glass
2 minGently swing the digitizer glass open from the left edge like the cover of a book.
- 5
Remove LCD corner screws
3 minUse a Phillips #00 screwdriver to remove the four corner screws securing the LCD display panel.
- 6
Lift LCD panel
2 minGently pry up the top edge of the LCD screen and fold it downward onto the opened digitizer.
- 7
Unscrew cable bracket
2 minRemove the three Phillips screws securing the metal shield over the logic board connectors.
- 8
Disconnect battery power
2 minInsert a plastic card or pick beneath the battery contact screw pad to disconnect power from the board.
- 9
Disconnect display cables
3 minUse a spudger to pry the LCD and digitizer ribbon cable connectors straight up from their sockets.
- 10
Unscrew speaker assemblies
4 minRemove the Phillips screws fastening the lower left and right speaker enclosures to the iPad frame.
- 11
Pry out original speakers
3 minInsert a flat plastic tool under each speaker module to release the light adhesive holding them in place.
- 12
Install replacement speakers
3 minAlign the new speaker units into the lower frame housing and press down to set them in place.
- 13
Secure speaker screws
3 minThread and tighten the Phillips screws to secure both replacement speaker modules to the chassis.
- 14
Reconnect display flex cables
4 minPress the digitizer and LCD connectors firmly onto the board until they snap, then remove the battery blocker.
- 15
Reinstall bracket and seal glass
5 minReplace the shield bracket with its screws, apply fresh adhesive strips, and firmly press the front glass shut.
After your Apple iPad 5 speaker repair
Power the iPad 5 back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Apple iPad 5 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Apple iPad 5 repair context in the encyclopedia, or open related DIY guides.
