Step-by-step

1. 1

   Power Off Device

   1 min

   Press and hold the power button, then tap Power Off on the screen. Ensure the tablet is completely shut down before continuing.

2. 2

   Equip Anti-Static Strap

   1 min

   Attach an anti-static wrist strap to your wrist and connect the clip to a grounded metal object. This prevents ESD damage to internal circuits.

3. 3

   Insert Plastic Pry Tool

   2 min

   Wedge a thin plastic opening tool into the thin seam between the plastic back cover and the display bezel near the top corner.

4. 4

   Unclip Top Edge

   2 min

   Gently lever the opening tool while sliding it along the top edge to disengage the plastic retaining clips.

5. 5

   Separate Side Clips

   3 min

   Slide the tool down the left and right edges of the chassis, twisting slightly to release each clip along the sides.

6. 6

   Release Bottom Clips

   2 min

   Run the tool across the bottom edge of the frame to release the final set of housing clips.

7. 7

   Remove Rear Case

   1 min

   Lift the rear plastic cover straight off the device body and set it aside.

8. 8

   Peel Protective Tape

   1 min

   Use fine-tip tweezers to carefully peel away the black electrical tape covering the battery connector and motherboard area.

9. 9

   Disconnect Battery Plug

   2 min

   Insert the flat edge of a spudger under the battery connector harness and pry straight up from the socket on the motherboard.

10. 10

    Remove Bracket Screws

    2 min

    Use a Phillips #00 screwdriver to unfasten the small screws securing the battery retaining bracket to the frame.

11. 11

    Apply Isopropyl Alcohol

    3 min

    Apply a few drops of high-concentration isopropyl alcohol along the exposed edges of the battery cell to soften the glue beneath.

12. 12

    Insert Plastic Opening Card

    2 min

    Slide a flexible plastic opening card underneath the top corner of the battery pack.

13. 13

    Pry Up Battery

    4 min

    Slowly push the plastic card under the battery, levering upward to slice through the adhesive strips without bending the cell.

14. 14

    Remove Old Battery

    1 min

    Lift the battery out of the frame chassis once completely freed from the adhesive.

15. 15

    Clean Battery Recess

    3 min

    Wipe away remaining adhesive residue from the metal recess using a lint-free cloth dampened with isopropyl alcohol.

16. 16

    Apply New Adhesive Strips

    2 min

    Lay down fresh double-sided battery adhesive strips into the recessed tray, peeling off the protective backing.

17. 17

    Install Replacement Battery

    2 min

    Position the new battery into the cavity and press down evenly across the surface to set it into the adhesive.

18. 18

    Plug In Battery Connector

    2 min

    Align the battery plug directly over its socket on the motherboard and press down firmly until it clicks into place.

19. 19

    Reattach Bracket Screws

    2 min

    Reposition the metal battery bracket and reinsert the Phillips screws until snug.

20. 20

    Snap Rear Cover On

    3 min

    Align the back cover over the tablet frame and press along all four edges until every perimeter clip snaps closed.