Phone · Samsung · Galaxy S24
Samsung Galaxy S24 Speaker Repair
Speaker Repair guide for the Samsung Galaxy S24
Before you begin
Tools
- Phillips #00 screwdriver
- Heat gun or iOpener
- Suction handle
- Opening picks
- Plastic spudger
- Precision tweezers
- Anti-static wrist strap
Parts / materials
- Replacement Samsung Galaxy S24 loudspeaker assembly
- Pre-cut back glass adhesive strip
- 99% Isopropyl alcohol
Safety
- Wear protective safety glasses when heating glass to shield eyes from potential splinters.
- Power down the phone completely before contacting internal motherboard components.
- Avoid applying direct pressure or prying force against the battery pouch.
Overview
Step-by-step
- 1
Power off the Galaxy S24
1 minPress and hold the side button and volume down button, then select Power Off on the screen.
- 2
Heat the rear glass panel
3 minApply a heated iOpener or heat gun to the edges of the back glass for two minutes to soften the internal adhesive.
- 3
Attach suction cup to rear glass
2 minPlace a suction cup on the lower portion of the back panel and pull up firmly to create a small gap.
- 4
Insert an opening pick
2 minSlide the tip of an opening pick into the gap between the glass panel and the aluminum frame.
- 5
Slice the perimeter adhesive
5 minSlide the pick carefully around all four edges of the back glass to slice through the adhesive seal.
- 6
Remove the back glass
2 minLift the back glass off the frame completely and set it aside on a clean surface.
- 7
Unscrew the wireless charging coil shield
4 minUse a Phillips #00 screwdriver to remove the screws securing the upper wireless charging pad assembly.
- 8
Remove the wireless charging coil
3 minDisconnect the pad flex connector from the motherboard and peel the coil off the battery.
- 9
Unscrew the lower speaker housing
3 minRemove the Phillips screws holding the lower loudspeaker module at the bottom of the frame.
- 10
Pry up the faulty speaker
2 minInsert a spudger under the notched edge of the loudspeaker assembly and gently pop it out of the chassis.
- 11
Install the new loudspeaker assembly
2 minAlign the replacement speaker module into the bottom recessed bay and press firmly until it snaps into position.
- 12
Secure the speaker screws
3 minReinstall and tighten the Phillips screws to firmly lock the loudspeaker module into the phone frame.
- 13
Reinstall the wireless charging coil
4 minReconnect the wireless charging flex cable to the motherboard and fasten all retaining screws.
- 14
Apply new back glass adhesive
5 minClean remaining glue with isopropyl alcohol, then apply new pre-cut adhesive strips along the frame perimeter.
- 15
Reattach the rear glass
3 minAlign the back glass panel over the chassis and press firmly along all edges to seat the adhesive.
After your Samsung Galaxy S24 speaker repair
Power the Galaxy S24 back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Samsung Galaxy S24 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Samsung Galaxy S24 repair context in the encyclopedia, or open related DIY guides.
