Phone · Samsung · Galaxy S24 Ultra
Samsung Galaxy S24 Ultra Logic Board Repair
Logic Board Repair guide for the Samsung Galaxy S24 Ultra
Before you begin
Tools
- Heat gun or hair dryer
- Suction cup tool
- Plastic prying tools
- Precision screwdriver set (Phillips #000)
- Spudger tool
- Tweezers
- SIM eject tool
Parts / materials
- Rear glass adhesive strips
- Isopropyl alcohol (99%)
- Thermal paste
Safety
- Power off the device completely before beginning disassembly.
- Wear safety glasses while heating and prying glass components.
- Always disconnect the battery connector first before handling any circuit board elements.
Overview
Step-by-step
- 1
Eject S-Pen and SIM tray
2 minInsert a SIM eject tool into the bottom pinhole to remove the SIM tray. Press and remove the S-Pen from its slot.
- 2
Heat the rear glass panel
3 minApply heat around the perimeter of the back cover for 2 to 3 minutes to soften the internal adhesive.
- 3
Slice the rear panel adhesive
5 minAttach a suction cup near the bottom edge, pull upward, and insert an opening pick into the seam. Carefully slide the pick around all edges.
- 4
Lift off the rear glass
2 minCarefully tilt up and remove the back glass panel from the chassis once all adhesive is cut.
- 5
Unscrew the top motherboard bracket
4 minUse a Phillips #000 screwdriver to remove the screws securing the upper wireless charging coil and antenna assembly.
- 6
Remove the wireless charging assembly
2 minPeel back the graphite sheet and lift the top plastic bracket away from the frame.
- 7
Disconnect the battery cable
1 minUse the flat end of a plastic spudger to pry the battery press connector straight up from its socket.
- 8
Disconnect the display flex cable
2 minPry up the main display ribbon cable connector attached to the lower section of the logic board.
- 9
Disconnect the interconnect flex cables
2 minUnplug the auxiliary and sub-board flex connectors from the motherboard using a plastic spudger.
- 10
Disconnect the front camera
2 minPry up the selfie camera connector press-fit socket and lift the camera out of its housing recess.
- 11
Remove the logic board securing screw
2 minUnscrew the single Phillips screw fixing the top logic board assembly to the aluminum frame.
- 12
Lift out the logic board
2 minGently pry beneath the edges of the logic board with a spudger and remove it from the device frame.
- 13
Apply fresh thermal paste
3 minClean off old thermal pad residue on the vapor chamber area and apply a small drop of fresh thermal paste.
- 14
Position the new logic board
3 minLower the replacement logic board into the frame, ensuring all underlying flex cables remain accessible.
- 15
Reconnect all motherboard connectors
4 minSnap the display, interconnect, camera, and battery cables firmly back onto their logic board sockets.
- 16
Reinstall the top bracket
4 minAlign the upper shield and wireless charging assembly, then tighten all reserved Phillips screws.
- 17
Reseal the back glass panel
5 minApply new perimeter adhesive tape to the frame, align the rear glass, and press firmly along the edges.
After your Samsung Galaxy S24 Ultra logic board repair
Power the Galaxy S24 Ultra back on and test the logic board repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Samsung Galaxy S24 Ultra job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Samsung Galaxy S24 Ultra repair context in the encyclopedia, or open related DIY guides.
