Phone · Samsung · Galaxy S22 Plus
Samsung Galaxy S22 Plus Speaker Repair
Speaker Repair guide for the Samsung Galaxy S22 Plus
Before you begin
Tools
- Phillips #00 screwdriver
- Plastic opening picks
- Suction handle
- Spudger
- Heat gun or iOpener
- SIM eject tool
- Tweezers
Parts / materials
- Replacement Samsung Galaxy S22 Plus loudspeaker module
- Pre-cut rear panel adhesive gasket
- Isopropyl alcohol (99%)
Safety
- Wear safety glasses while heating and removing glass panels to protect against sharp fragments.
- Keep heat gun temperatures below 80°C to prevent thermal damage to the internal battery.
- Always disconnect the battery press connector before removing or installing internal components.
Overview
Step-by-step
- 1
Power down the device
1 minPress and hold the side button and volume down button, then select Power Off on the screen.
- 2
Eject the SIM tray
1 minInsert a SIM eject tool into the hole on the bottom edge of the phone to pop out the tray.
- 3
Heat the rear panel
2 minApply a heat gun or heated iOpener around the edges of the back cover for two minutes to soften the perimeter adhesive.
- 4
Slice the back cover adhesive
3 minAttach a suction cup near the bottom edge, pull upward gently, and insert an opening pick into the resulting gap.
- 5
Separate the back cover
3 minSlide the opening pick around all four edges to cut the remaining adhesive, then lift off the rear glass.
- 6
Unscrew the motherboard bracket
2 minRemove the five Phillips #00 screws securing the upper motherboard bracket and wireless charging coil assembly.
- 7
Remove the motherboard bracket
2 minGently unclip and lift out the wireless charging coil assembly using a plastic spudger.
- 8
Disconnect the battery
1 minPry the battery press connector straight up from its motherboard socket using a plastic spudger to prevent short circuits.
- 9
Unscrew the loudspeaker module
2 minRemove the six Phillips #00 screws securing the bottom loudspeaker assembly to the lower frame.
- 10
Remove the loudspeaker module
2 minInsert a spudger beneath the edge of the loudspeaker housing and pry it up from the chassis.
- 11
Position the replacement loudspeaker
2 minAlign the new loudspeaker module into the lower frame recess and press it flat against the alignment pins.
- 12
Secure the loudspeaker module
2 minReinstall and tighten the six Phillips #00 screws to hold the loudspeaker assembly in place.
- 13
Reconnect the battery
1 minAlign the battery press connector over its motherboard socket and press down firmly until it clicks.
- 14
Reattach the motherboard bracket
2 minPlace the wireless charging coil back onto the motherboard and fasten it with the five Phillips #00 screws.
- 15
Seal the rear panel
3 minApply new pre-cut adhesive strips to the frame perimeter and press the rear glass firmly down into place.
After your Samsung Galaxy S22 Plus speaker repair
Power the Galaxy S22 Plus back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Samsung Galaxy S22 Plus job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Samsung Galaxy S22 Plus repair context in the encyclopedia, or open related DIY guides.
