Skip to main content

Phone · OnePlus · Nord N300 5G

OnePlus Nord N300 5G Screen Replacement

Screen Replacement guide for the OnePlus Nord N300 5G

Difficult
~47 min
22 steps

Before you begin

Tools

  • Heat gun or hair dryer
  • Plastic prying tools
  • Suction cup tool
  • Spudger tool
  • Precision screwdriver set (Phillips #000)
  • Tweezers
  • SIM eject tool

Parts / materials

  • Replacement screen assembly
  • Double-sided adhesive strips
  • Rear panel adhesive
  • Isopropyl alcohol (91%+)

Safety

  • Wear safety glasses to protect your eyes from cracked glass fragments.
  • Disconnect the battery before handling internal components to avoid electrical shorts.
  • Do not overheat the phone to prevent damaging the battery.

Overview

# OnePlus Nord N300 5G Screen Replacement Repair Guide Action-specific screen replacement walkthrough for the OnePlus Nord N300 5G. About 47 minutes across 22 steps. This DIY guide walks through screen replacement on the OnePlus Nord N300 5G (Nord series phone). Before you open the device, confirm the exact model number on the OnePlus settings screen or rear housing so your replacement part matches the Nord N300 5G specifically—not a similar Nord sibling. Most DIY techs finish this OnePlus Nord N300 5G screen replacement in about 47 minutes when parts and tools are ready. Difficulty is rated advanced for this model. Recommended tools for this OnePlus Nord N300 5G job: Heat gun or hair dryer, Plastic prying tools, Suction cup tool, Spudger tool, Precision screwdriver set (Phillips #000), Tweezers, SIM eject tool. Parts and supplies: Replacement screen assembly, Double-sided adhesive strips, Rear panel adhesive, Isopropyl alcohol (91%+). Power the Nord N300 5G off completely, remove SIMs/SD cards if present, and work on a clean, well-lit surface with a magnetic mat for screws. If a step feels wrong for your OnePlus Nord N300 5G, stop and compare the connector layout to the photos in this guide. When you prefer a same-day pro repair in Seattle instead, LML Repair can handle screen replacement for this model with tested parts and a workmanship warranty.

Step-by-step

  1. 1

    Turn off the phone

    1 min

    Press and hold the Power and Volume Up buttons simultaneously, then select Power Off on the screen.

  2. 2

    Eject the SIM tray

    1 min

    Insert a SIM eject tool into the hole next to the SIM tray on the left edge of the phone to pop it out.

  3. 3

    Heat the rear panel

    2 min

    Use a heat gun or hair dryer to apply warm air around all edges of the rear cover for 2 minutes to soften the adhesive.

  4. 4

    Slice rear panel adhesive

    3 min

    Attach a suction cup near the bottom edge of the back panel, pull up gently, and insert a plastic pick to cut through the adhesive along the edges.

  5. 5

    Lift off rear cover

    2 min

    Slowly pivot the rear panel open and lift it completely off the frame once all adhesive is severed.

  6. 6

    Remove upper bracket screws

    2 min

    Use a Phillips #000 screwdriver to remove the screws securing the plastic motherboard shield.

  7. 7

    Detach upper bracket

    2 min

    Insert a spudger under the motherboard shield and gently unclip it from the chassis.

  8. 8

    Disconnect battery cable

    1 min

    Use the flat end of a plastic spudger to pop the battery connector straight up from its socket on the motherboard.

  9. 9

    Remove speaker assembly screws

    2 min

    Unscrew the Phillips screws securing the bottom speaker enclosure to the frame.

  10. 10

    Detach speaker module

    2 min

    Pry up the lower speaker module with a spudger and remove it from the phone.

  11. 11

    Disconnect display flex cable

    1 min

    Use a plastic spudger to disconnect the main screen flex cable from the circuit board.

  12. 12

    Heat display assembly

    3 min

    Apply heat evenly across the front glass perimeter for 2-3 minutes to soften the display adhesive.

  13. 13

    Slice display glass adhesive

    4 min

    Apply a suction cup to the lower display edge, raise a small gap, and slice around the frame with an opening pick.

  14. 14

    Remove display assembly

    2 min

    Feed the display flex cable through the slot in the frame and lift the screen away from the device body.

  15. 15

    Clean frame adhesive

    4 min

    Scrape away old tape fragments from the metal frame using a spudger and wipe the perimeter clean with isopropyl alcohol.

  16. 16

    Apply new display adhesive

    3 min

    Lay fresh custom-cut adhesive strips along the thin outer ledges of the front frame.

  17. 17

    Install replacement screen

    3 min

    Guide the flex cable of the new screen through the frame slot and seat the screen into the frame.

  18. 18

    Reconnect display cable

    1 min

    Press the screen flex cable connector gently onto the motherboard until it clicks into place.

  19. 19

    Reconnect battery cable

    1 min

    Press the battery flex cable connector firmly back into its socket.

  20. 20

    Reinstall plastic housing brackets

    3 min

    Position the speaker module and upper motherboard shield back into place and tighten all Phillips screws.

  21. 21

    Seal rear cover

    3 min

    Apply fresh rear cover adhesive, align the back panel over the body, and press firmly around all edges.

  22. 22

    Reinsert SIM tray

    1 min

    Push the SIM card tray fully back into its slot on the side of the phone.

After your OnePlus Nord N300 5G screen replacement

Power the Nord N300 5G back on and test the screen replacement function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this OnePlus Nord N300 5G job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.

Keep learning

Explore more OnePlus Nord N300 5G repair context in the encyclopedia, or open related DIY guides.

logo_footer

Stay in the loop

Get new guides, reviews, and repair news.

© 2026 LML Repair. All rights reserved.