Step-by-step

1. 1

   Turn Off the Phone

   1 min

   Press and hold the Power and Volume Up buttons until the power menu appears. Select Power Off to shut down the device completely.

2. 2

   Remove the SIM Card Tray

   1 min

   Insert a SIM eject tool into the hole next to the SIM tray on the left frame edge. Push firmly inward to eject the tray, then remove it.

3. 3

   Heat the Back Cover

   2 min

   Apply heat using a heat gun or hair dryer around the outer edges of the rear panel for two minutes. This softens the adhesive securing the back cover.

4. 4

   Attach Suction Cup

   1 min

   Place a suction cup near the bottom edge of the rear cover. Pull upward on the ring gently to create a tiny gap between the cover and the frame.

5. 5

   Slice Back Cover Adhesive

   3 min

   Insert a plastic prying pick into the gap made by the suction cup. Slide the pick around the entire perimeter to slice through the remaining adhesive.

6. 6

   Lift Off the Back Cover

   1 min

   Carefully lift the rear panel off the phone body. Set the back panel aside on a clean, dust-free surface.

7. 7

   Unbolt Lower Assembly Screws

   2 min

   Use a Phillips #000 screwdriver to remove the screws securing the plastic speaker cover housing at the bottom of the phone. Store the screws safely.

8. 8

   Disconnect the Battery Flex Cable

   2 min

   Pry up the upper motherboard shield if necessary and use a plastic spudger to disconnect the battery connector. This cuts power and prevents short circuits.

9. 9

   Pry Up the Loudspeaker Module

   2 min

   Insert a flat spudger beneath the edge of the bottom loudspeaker housing. Pry gently upward to detach the speaker module from the frame.

10. 10

    Transfer Rubber Gaskets

    2 min

    Inspect the original speaker for rubber mesh gaskets or anti-vibration pads using tweezers. Transfer any loose components onto the replacement speaker.

11. 11

    Install New Loudspeaker Module

    2 min

    Position the new loudspeaker module into the lower frame cavity. Press down evenly until it snaps securely into place.

12. 12

    Reconnect Battery Flex Cable

    1 min

    Align the battery press connector over its socket on the motherboard. Press down firmly with your thumb until you feel it click into place.

13. 13

    Secure Lower Module Screws

    2 min

    Reinsert and tighten all Phillips screws into the lower speaker housing. Ensure the module sits flush against the frame.

14. 14

    Apply Back Cover Adhesive

    3 min

    Clean remaining adhesive off the frame edges using isopropyl alcohol. Apply new pre-cut adhesive tape along the perimeter of the phone chassis.

15. 15

    Reattach the Back Cover

    2 min

    Align the rear panel over the frame and press down firmly around all edges. Maintain pressure for 30 seconds to ensure a secure bond.

16. 16

    Reinsert the SIM Card Tray

    1 min

    Align the SIM card tray with its slot on the side of the phone. Push the tray straight in until it sits flush against the outer housing.