Step-by-step

1. 1

   Power off the phone

   1 min

   Press and hold the power button, then tap Power Off on the screen. Ensure the device is completely powered down before beginning.

2. 2

   Eject the SIM tray

   1 min

   Insert the SIM eject tool into the hole next to the tray on the left side of the frame. Push firmly to eject the tray and set it aside.

3. 3

   Heat the rear panel

   2 min

   Apply heat evenly across the edges of the back cover using a heat gun set to low heat for approximately 2 minutes. This softens the underlying adhesive.

4. 4

   Attach the suction cup

   1 min

   Press a suction cup firmly onto the lower portion of the rear panel, near the bottom edge.

5. 5

   Create an opening seam

   2 min

   Pull up gently on the suction cup while steadying the frame to form a slight gap along the bottom edge. Insert a thin plastic opening pick into the seam.

6. 6

   Slice the perimeter adhesive

   3 min

   Slide the pick slowly around all edges of the rear cover to cut through the glue. Reheat the edges if the pick begins to catch or stick.

7. 7

   Remove the back cover

   1 min

   Lift the rear panel away from the chassis carefully. Set it on a clean work surface.

8. 8

   Unscrew the loudspeaker cover

   2 min

   Remove the seven Phillips #000 screws securing the lower plastic speaker housing to the sub-frame.

9. 9

   Pry out the loudspeaker

   2 min

   Insert a spudger under the notch on the speaker housing and pry upward to free it. Remove the loudspeaker module completely.

10. 10

    Disconnect the main flex cable

    1 min

    Pry the main interconnect flex cable straight up from its connector socket on the sub-board using a spudger.

11. 11

    Disconnect the antenna cable

    1 min

    Use precision tweezers to pry up the small coaxial antenna cable head from its terminal on the sub-board.

12. 12

    Remove the microphone sub-board

    2 min

    Slide a flat spudger beneath the lower sub-board and lift it out of the phone recess.

13. 13

    Clear the microphone channel

    2 min

    Inspect the mic port opening on the bottom of the phone frame and remove any dust using tweezers or compressed air.

14. 14

    Position the new sub-board

    2 min

    Place the replacement sub-board into the lower recess, aligning the rubber microphone gasket directly over the port hole.

15. 15

    Reconnect the antenna cable

    1 min

    Align the antenna cable connector over its press-fit socket on the sub-board and press down lightly until it snaps into place.

16. 16

    Reconnect the main flex cable

    1 min

    Press the main flex connector firmly onto the sub-board socket until it locks into position.

17. 17

    Reinstall the loudspeaker

    2 min

    Place the loudspeaker housing back over the bottom sub-board assembly and press down gently. Secure it with the seven Phillips #000 screws.

18. 18

    Apply new back cover adhesive

    3 min

    Clean off remaining original adhesive from the frame perimeter with isopropyl alcohol, then stick pre-cut adhesive tape along the rim.

19. 19

    Seal the back cover

    2 min

    Align the rear panel over the frame and press down firmly around all edges to bond the adhesive completely.