Phone · OnePlus · Nord 2T
OnePlus Nord 2T Speaker Repair
Speaker Repair guide for the OnePlus Nord 2T
Before you begin
Tools
- Heat gun or hair dryer
- Suction cup tool
- Plastic prying tools
- Phillips #000 screwdriver
- Spudger tool
- Tweezers
Parts / materials
- Replacement loudspeaker module
- Precut rear cover adhesive
- 90%+ Isopropyl alcohol
- Lint-free cleaning cloth
Safety
- Disconnect or power down the device before starting any disassemblies to avoid electrical shorts.
- Wear safety glasses when applying heat to glass surfaces to protect against potential shattering.
- Avoid overheating the battery area during the back cover removal process.
Overview
Step-by-step
- 1
Power off the device
1 minPress and hold the Power and Volume Up buttons, then tap Power Off on the screen.
- 2
Heat the back glass edge
2 minApply heat to the rear edges of the phone for two minutes using a heat gun to soften the adhesive.
- 3
Apply suction cup
2 minPlace a suction cup near the bottom edge of the back glass and pull up gently to create a small gap.
- 4
Insert opening pick
2 minSlide a thin plastic prying pick into the gap between the frame and the rear glass panel.
- 5
Slice perimeter adhesive
4 minSlide the pick around all four edges of the phone to cut through the remaining adhesive tape.
- 6
Lift off back glass
1 minGently lift the back glass off the frame and place it safely aside on your work mat.
- 7
Remove bottom bracket screws
3 minUse a Phillips #000 screwdriver to remove the Phillips screws securing the lower speaker cover assembly.
- 8
Pry up loudspeaker module
2 minInsert a spudger under the edge of the lower plastic bracket and lever it up to release the clips.
- 9
Remove faulty loudspeaker
1 minLift the loudspeaker assembly out of the lower chassis housing using tweezers.
- 10
Set new loudspeaker
2 minAlign the replacement loudspeaker into the lower recess and press down lightly to seat it.
- 11
Fasten speaker bracket screws
3 minReinstall and tighten the Phillips screws to firmly secure the loudspeaker cover in place.
- 12
Clean residual adhesive
3 minUse isopropyl alcohol and a lint-free cloth to remove old adhesive strips from the frame edges.
- 13
Reattach back glass
3 minApply new adhesive precut tape along the perimeter, then press the back cover firmly onto the body.
After your OnePlus Nord 2T speaker repair
Power the Nord 2T back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this OnePlus Nord 2T job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more OnePlus Nord 2T repair context in the encyclopedia, or open related DIY guides.
