Step-by-step

1. 1

   Power Off the Phone

   2 min

   Press and hold the power button on the right edge, then select Power Off on the screen. Ensure the device is fully shut down before proceeding.

2. 2

   Remove the SIM Card Tray

   1 min

   Insert a SIM eject tool into the hole on the left edge of the device to pop out the SIM tray. Pull the tray completely out and set it aside.

3. 3

   Heat the Back Cover Edges

   3 min

   Apply heat from a heat gun or hair dryer along all four edges of the back cover for 2 to 3 minutes. This softens the underlying perimeter adhesive.

4. 4

   Attach Suction Cup

   1 min

   Place a suction cup onto the lower portion of the back cover near the USB-C port. Press down firmly to create a tight seal.

5. 5

   Insert Plastic Pick

   2 min

   Pull up gently on the suction cup to create a small gap between the back cover and frame. Insert a thin plastic opening pick into the gap.

6. 6

   Slice Back Cover Adhesive

   4 min

   Slide the plastic pick carefully around all sides of the phone to separate the back cover adhesive. Reapply heat if the pick meets heavy resistance.

7. 7

   Remove the Back Cover

   1 min

   Lift the rear back cover off the chassis once all adhesive has been severed. Store the back cover in a safe location.

8. 8

   Unscrew the Midframe

   5 min

   Use a Phillips #000 screwdriver to remove the 16 screws securing the midframe and motherboard cover assembly.

9. 9

   Unclip and Remove Midframe

   3 min

   Insert the flat end of a spudger around the inner edges of the plastic midframe to release its retaining clips. Lift the midframe away from the device.

10. 10

    Disconnect Battery Connector

    1 min

    Pry the battery press connector straight up from its socket on the motherboard using a plastic spudger. This cuts power to the device completely.

11. 11

    Disconnect Display Cable

    1 min

    Use a spudger to detach the display flex cable connector positioned above the battery. Gently bend it back to clear path for battery removal.

12. 12

    Apply Isopropyl Alcohol

    2 min

    Dispense a few drops of high-concentration isopropyl alcohol along the side edges of the battery well. Allow 1 to 2 minutes for the adhesive to break down.

13. 13

    Pry Out the Battery

    4 min

    Insert a flat plastic card or wide spudger underneath the battery from the side. Slowly lever the battery upward until it fully detaches from the frame.

14. 14

    Clean the Battery Bay

    2 min

    Wipe away residual glue inside the battery housing using a lint-free cloth lightly dampened with isopropyl alcohol.

15. 15

    Apply Replacement Adhesive

    2 min

    Peel the backing off new battery adhesive strips and lay them flat inside the battery compartment. Press down firmly to secure the tape to the chassis.

16. 16

    Install the New Battery

    2 min

    Align the replacement battery over the adhesive strips and lower it into place. Press the battery flex cable firmly into its motherboard socket.