Phone · Motorola · Moto G62 5G
Motorola Moto G62 5G Speaker Repair
Speaker Repair guide for the Motorola Moto G62 5G
Before you begin
Tools
- Phillips #000 Screwdriver
- Heat gun or hair dryer
- Suction cup tool
- Plastic prying tools
- Spudger tool
- Tweezers
- SIM eject tool
Parts / materials
- Replacement Moto G62 5G loudspeaker module
- Back cover adhesive strips
- Isopropyl alcohol (91% or higher)
Safety
- Wear safety glasses to protect your eyes when heating and prying.
- Do not puncture or bend the internal battery during disassembly.
- Keep heat gun temperatures moderate to avoid melting plastic internal components.
Overview
Step-by-step
- 1
Power Off Phone
1 minPress and hold the power button, then select Power Off on the screen to completely shut down the device.
- 2
Eject SIM Tray
1 minInsert a SIM eject tool into the small hole on the left edge of the phone to pop out the SIM card tray.
- 3
Heat Back Cover
2 minApply a heat gun or hair dryer evenly across the rear panel for two minutes to soften the internal adhesive.
- 4
Attach Suction Cup
2 minPlace a suction cup near the bottom edge of the back panel and pull gently upward to create a small gap.
- 5
Insert Opening Pick
1 minSlide a thin plastic opening pick into the gap between the rear panel and the phone frame.
- 6
Slice Rear Adhesive
3 minCarefully slide the opening pick along the entire perimeter of the back panel to slice through the remaining adhesive.
- 7
Remove Back Cover
1 minLift the rear panel clear off the chassis and lay it flat on your workspace.
- 8
Unscrew Loudspeaker Housing
3 minUse a Phillips #000 screwdriver to remove the screws securing the lower speaker cover assembly.
- 9
Remove Speaker Module
2 minInsert the tip of a spudger under the edge of the loudspeaker assembly and gently lever it out of the frame.
- 10
Install New Loudspeaker
2 minPosition the new loudspeaker assembly into the lower recess and press down lightly until it sits flush.
- 11
Fasten Housing Screws
3 minReinstall and tighten the Phillips screws to firmly secure the loudspeaker module in place.
- 12
Apply New Adhesive
3 minClean remaining old glue with isopropyl alcohol, then apply pre-cut adhesive strips along the rear frame edges.
- 13
Reattach Back Cover
2 minAlign the rear panel with the frame and press firmly along all edges to seat the adhesive.
- 14
Reinsert SIM Tray
1 minPush the SIM card tray back into its slot on the side of the phone until it clicks flush.
After your Motorola Moto G62 5G speaker repair
Power the Moto G62 5G back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto G62 5G job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto G62 5G repair context in the encyclopedia, or open related DIY guides.
