Phone · Motorola · Moto G62 5G
Motorola Moto G62 5G Logic Board Repair
Logic Board Repair guide for the Motorola Moto G62 5G
Before you begin
Tools
- Phillips #00 screwdriver
- Heat gun or hair dryer
- Suction cup tool
- Plastic opening picks
- Spudger tool
- Tweezers
- SIM eject tool
Parts / materials
- Replacement rear cover adhesive strips
- Isopropyl alcohol (99%)
Safety
- Wear an anti-static wrist strap to prevent ESD damage to sensitive electronic components.
- Disconnect the battery press connector immediately after opening the device to prevent short circuits.
- Avoid bending or puncturing the battery while heating or working near the frame.
Overview
Step-by-step
- 1
Power Down the Device
1 minPress and hold the power button on the Moto G62 5G, then select Power Off on the screen.
- 2
Eject the SIM Card Tray
1 minInsert a SIM eject tool into the hole on the left edge of the phone to pop out and remove the tray.
- 3
Heat the Rear Cover
3 minApply a heat gun or hair dryer around the edges of the back panel for 2 to 3 minutes to soften the adhesive.
- 4
Slice the Rear Cover Adhesive
5 minAttach a suction cup near the bottom edge, lift slightly, and insert a plastic opening pick to slice around the perimeter.
- 5
Remove the Rear Cover
1 minCarefully lift off the rear plastic cover and set it aside on your clean workspace mat.
- 6
Unscrew the Upper Frame Shield
3 minUse a Phillips #00 screwdriver to remove all screws securing the top plastic motherboard bracket.
- 7
Pry Off the Upper Frame Shield
2 minInsert a spudger under the top plastic bracket edge and gently unclip it from the housing.
- 8
Disconnect the Battery Cable
1 minUse the flat end of a plastic spudger to snap off the battery press connector from the motherboard.
- 9
Disconnect the Fingerprint Sensor Cable
1 minLocate the side-mounted fingerprint scanner ribbon cable and disconnect it using your spudger.
- 10
Disconnect Display and Interconnect Ribbons
2 minLever up the display flex cable and the main bottom board ribbon cable connectors from the logic board.
- 11
Disconnect the Antenna Cables
2 minUse precision tweezers to unclip the white and black coaxial antenna cables from their board sockets.
- 12
Remove the Camera Modules
3 minDisconnect the rear camera array and front selfie camera press connectors, then lift the camera modules out.
- 13
Unscrew the Logic Board Standoff Screw
1 minRemove the single Phillips #00 screw anchoring the logic board directly to the phone chassis.
- 14
Lift Out the Logic Board
2 minInsert a flat spudger under the bottom edge of the logic board and lift it gently out of the frame.
After your Motorola Moto G62 5G logic board repair
Power the Moto G62 5G back on and test the logic board repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto G62 5G job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto G62 5G repair context in the encyclopedia, or open related DIY guides.
