Step-by-step

1. 1

   Power Down the Device

   1 min

   Press and hold the power button on the right side of the phone, then tap Power Off on the screen. Wait until the display completely shuts down.

2. 2

   Attach Anti-Static Strap

   1 min

   Put on an anti-static wrist strap and connect it to a grounded metal object. This prevents static discharge from damaging internal electronics.

3. 3

   Locate Back Cover Notch

   1 min

   Inspect the bottom edge of the phone to locate the small opening notch on the back cover. This notch provides leverage to pop off the cover.

4. 4

   Insert Opening Tool

   1 min

   Insert the edge of a plastic opening pick into the bottom removal notch. Apply gentle upward pressure until the first corner unclips.

5. 5

   Pry Bottom Edge

   2 min

   Slide the plastic pick horizontally along the bottom seam of the back cover. Continue until all bottom retaining clips release.

6. 6

   Unclip Left Side

   2 min

   Move the pick up along the left edge of the phone body. Pry gently to disengage the plastic clips along this side.

7. 7

   Unclip Right Side

   2 min

   Slide the pick along the right edge near the power and volume buttons. Release the remaining side clips without forcing the plastic.

8. 8

   Separate Back Cover

   1 min

   Lift the back cover away from the phone chassis entirely. Set the cover aside in a clean, dust-free spot.

9. 9

   Locate Battery Recess

   1 min

   Find the small pry recess located at the bottom of the battery compartment. This notch is meant specifically for battery extraction.

10. 10

    Pry Battery Upward

    1 min

    Insert a flat plastic spudger into the battery recess. Lever the spudger upward to dislodge the battery from the housing.

11. 11

    Lift Out Battery

    1 min

    Grasp the dislodged battery by its plastic edges and lift it out of the phone. Place the old battery on an insulated surface.

12. 12

    Clean Terminal Contacts

    2 min

    Lightly wipe the metal battery contacts inside the compartment using a lint-free wipe with isopropyl alcohol. Allow it to air dry for 30 seconds.

13. 13

    Align New Battery Contacts

    1 min

    Position the replacement Motorola GK40 battery above the bay. Align its gold contacts with the metallic terminal pins inside the phone.

14. 14

    Press Battery Into Place

    1 min

    Insert the contact end of the battery first, then press down on the lower end. Ensure the battery sits completely flat inside the bay.

15. 15

    Align Back Cover

    1 min

    Place the rear cover onto the back of the phone. Ensure the rear camera opening fits properly around the camera module.

16. 16

    Snap Back Cover Closed

    2 min

    Pinch firmly along all outer edges of the phone frame. Continue pressing around the perimeter until every plastic clip snaps shut securely.

17. 17

    Perform Boot Test

    2 min

    Press and hold the power button until the Motorola logo appears on screen. Verify that the device turns on and displays correct battery level.