Skip to main content

Phone · Motorola · Moto G4 Plus

Rear Camera Repair Guide for Moto G4 Plus

Rear Camera Repair guide for the Motorola Moto G4 Plus

Moderate
~34 min
16 steps

Before you begin

Tools

  • Phillips #00 screwdriver
  • Plastic prying tools
  • Spudger tool
  • Tweezers
  • Anti-static wrist strap

Parts / materials

  • Replacement Moto G4 Plus rear camera module
  • Isopropyl alcohol (optional for cleaning lens area)

Safety

  • Disconnect the battery before touching internal motherboard components to avoid short circuits.
  • Wear an anti-static wrist strap to prevent electrostatic discharge damage to delicate microelectronics.
  • Do not puncture or bend the lithium-ion battery during internal midframe removal.

Overview

# Rear Camera Repair Guide for Moto G4 Plus Action-specific rear camera repair walkthrough for the Motorola Moto G4 Plus. About 34 minutes across 16 steps. This DIY guide walks through rear camera repair on the Motorola Moto G4 Plus (Moto G series phone). Before you open the device, confirm the exact model number on the Motorola settings screen or rear housing so your replacement part matches the Moto G4 Plus specifically—not a similar Moto G sibling. Most DIY techs finish this Motorola Moto G4 Plus rear camera repair in about 34 minutes when parts and tools are ready. Difficulty is rated intermediate for this model. Recommended tools for this Motorola Moto G4 Plus job: Phillips #00 screwdriver, Plastic prying tools, Spudger tool, Tweezers, Anti-static wrist strap. Parts and supplies: Replacement Moto G4 Plus rear camera module, Isopropyl alcohol (optional for cleaning lens area). Power the Moto G4 Plus off completely, remove SIMs/SD cards if present, and work on a clean, well-lit surface with a magnetic mat for screws. If a step feels wrong for your Motorola Moto G4 Plus, stop safely, compare the connector layout to the photos in this guide, and re-check that your part matches this exact model. When you are unsure, read related guides for the same Moto G series or browse related common problems before forcing a connector.

Step-by-step

  1. 1

    Power off the phone

    1 min

    Press and hold the power button, then tap Power Off on the screen. Ensure the device is fully shut down before proceeding.

  2. 2

    Pry off the back cover

    2 min

    Insert a plastic prying tool or thumbnail into the notch near the USB charging port. Gently lift and pull the flexible back cover away from the phone body.

  3. 3

    Remove SIM and microSD trays

    1 min

    Slide out any installed SIM cards and microSD cards from their respective slots on the back of the device.

  4. 4

    Unscrew the midframe cover

    4 min

    Use a Phillips #00 screwdriver to remove all 19 screws securing the internal midframe plate.

  5. 5

    Peel back the camera accent sticker

    2 min

    Use tweezers to carefully lift the small dark sticker near the camera bump to expose any hidden frame clips or screws.

  6. 6

    Unclip and remove the midframe

    3 min

    Insert a plastic spudger between the outer edge of the frame and the display assembly. Pry around the perimeter to release the plastic clips and lift the midframe off.

  7. 7

    Disconnect the battery flex cable

    2 min

    Locate the battery connector on the motherboard. Pry it straight up with the flat end of a plastic spudger to cut power to the device.

  8. 8

    Disconnect the rear camera connector

    2 min

    Locate the rear camera press connector at the top of the motherboard. Pry the press connector straight up out of its socket using a spudger.

  9. 9

    Remove the damaged rear camera

    2 min

    Gently lift the rear camera module out of its recessed well on the motherboard using precision tweezers.

  10. 10

    Insert the new rear camera

    2 min

    Position the new rear camera module into the empty motherboard recess with the flex cable aligned toward the connector.

  11. 11

    Attach the camera flex connector

    2 min

    Align the press connector directly over its socket on the motherboard and press down firmly with your finger until it snaps into place.

  12. 12

    Reconnect the battery cable

    1 min

    Align the battery flex connector over its terminal and press down firmly to re-establish power.

  13. 13

    Snap the midframe back into place

    3 min

    Position the midframe cover over the back of the phone and press firmly along the edges until all plastic tabs snap closed.

  14. 14

    Reinstall all midframe screws

    4 min

    Use your Phillips #00 screwdriver to re-thread and tighten all 19 screws around the midframe housing.

  15. 15

    Reinsert SIM and microSD cards

    1 min

    Push your SIM card and microSD card back into their designated card slots until fully seated.

  16. 16

    Reattach the outer back cover

    2 min

    Place the rear plastic shell onto the back of the device and press around all edges until it snaps flush.

After your Motorola Moto G4 Plus rear camera repair

Power the Moto G4 Plus back on and test the rear camera repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto G4 Plus job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.

Keep learning

Explore more Motorola Moto G4 Plus repair context in the encyclopedia, or open related DIY guides.

logo_footer

Stay in the loop

Get new guides, reviews, and repair news.

© 2026 LML Repair. All rights reserved.