Step-by-step

1. 1

   Power off device

   1 min

   Press and hold the power button on your Moto G4 Plus, then select Power Off from the screen menu.

2. 2

   Remove back cover

   2 min

   Insert a plastic prying tool or fingernail into the notch near the micro-USB port and lift off the rear plastic panel.

3. 3

   Remove midframe screws

   5 min

   Use a Torx T3 driver to remove the nineteen screws securing the plastic midframe to the phone body.

4. 4

   Unclip inner midframe

   3 min

   Insert a spudger around the perimeter seam to release the plastic clips holding the midframe cover in place.

5. 5

   Lift midframe housing

   2 min

   Gently lift the inner midframe assembly away from the motherboard and set it on your workspace.

6. 6

   Heat old camera lens

   3 min

   Apply mild heat from a hair dryer or heat gun to the exterior camera glass for 30 seconds to soften the adhesive.

7. 7

   Push out damaged lens

   3 min

   Use the flat end of a spudger from inside the midframe housing to push the broken camera glass outward.

8. 8

   Clean adhesive residue

   4 min

   Clear out leftover glass fragments with tweezers and clean the lens bezel area using a lint-free cloth dabbed in isopropyl alcohol.

9. 9

   Apply camera lens adhesive

   2 min

   Peel the protective backing off the new pre-cut adhesive ring and press it firmly into the camera bezel channel.

10. 10

    Install new camera glass

    2 min

    Align the replacement glass lens cover over the adhesive and press down evenly using a microfiber cloth.

11. 11

    Reposition inner midframe

    2 min

    Place the inner midframe housing back onto the phone frame and snap the side tabs into place.

12. 12

    Secure midframe screws

    5 min

    Reinstall all nineteen Torx T3 screws firmly around the midframe perimeter.

13. 13

    Snap rear cover back on

    2 min

    Align the back plastic panel with the phone edges and press firmly along the border until every clip engages.