Step-by-step

1. 1

   Power Down Phone

   1 min

   Press and hold the power button, then tap Power Off on the screen. Ensure the device is completely powered down before proceeding.

2. 2

   Remove Back Cover

   2 min

   Insert a plastic opening tool into the notch at the bottom of the device. Pry upward to release the clips and remove the outer rear shell.

3. 3

   Remove SIM and MicroSD Cards

   1 min

   Slide out any installed SIM card and microSD card from their respective slots above the battery housing.

4. 4

   Unscrew Rear Midframe

   4 min

   Use a Torx T4 screwdriver to remove the 14 screws securing the plastic internal housing to the phone body.

5. 5

   Unclip Rear Inner Frame

   3 min

   Insert an opening pick into the seam between the front assembly and the inner frame. Pry along the perimeter to disengage plastic clips.

6. 6

   Lift Off Inner Frame Assembly

   2 min

   Gently lift the black plastic inner frame away from the main motherboard assembly and set it aside.

7. 7

   Disconnect Battery Connector

   1 min

   Use the edge of a plastic spudger to pry the battery flex connector straight up from its motherboard socket.

8. 8

   Remove Battery

   3 min

   Insert a flat plastic opening tool under the battery and carefully pry upward to break the light adhesive underneath.

9. 9

   Disconnect Display Flex Cable

   2 min

   Use tweezers or a spudger to flip up the locking zif latch and pull the display ribbon cable out of its connector.

10. 10

    Heat Screen Perimeter

    3 min

    Apply heat around the outer display edges using a heat gun set to low for approximately two minutes to soften the display adhesive.

11. 11

    Attach Suction Cup

    1 min

    Press a suction cup firmly onto the top half of the screen near the speaker grille.

12. 12

    Slice Screen Adhesive

    4 min

    Pull up gently on the suction cup and slide an opening pick between the glass screen and the plastic housing frame.

13. 13

    Guide Display Cable Through Slot

    2 min

    Pry the display screen away from the chassis while carefully guiding its flex cable through the slot in the frame.

14. 14

    Clean Frame Adhesive Residue

    4 min

    Scrape off residual glue and glass splinters using isopropyl alcohol and a flat tool so the new display lays flush.

15. 15

    Apply Screen Adhesive

    3 min

    Lay pre-cut adhesive strips precisely around the perimeter of the clean front chassis frame.

16. 16

    Thread Replacement Screen Cable

    2 min

    Pass the new display assembly's flex cable through the opening slot in the front frame chassis.

17. 17

    Set Display Assembly

    2 min

    Align the top and bottom edges of the screen with the frame, then press firmly around the perimeter to adhere it.

18. 18

    Connect Display Cable

    2 min

    Insert the display flex ribbon into its ZIF connector on the motherboard and close the locking latch.

19. 19

    Install Battery

    2 min

    Place the battery back into the compartment and press the battery connector straight down into the socket until it snaps.

20. 20

    Reattach Inner Frame

    2 min

    Align the internal plastic frame over the phone body and press down around the edges until it clicks into place.

21. 21

    Secure Midframe Screws

    3 min

    Reinsert and tighten the 14 Torx T4 screws around the inner frame until snug.

22. 22

    Snap On Back Cover

    2 min

    Place the outer rear cover over the device and press along all edges to snap the cover fully shut.