Phone · Motorola · Moto G24
Motorola Moto G24 Water Damage Repair
Water Damage Repair guide for the Motorola Moto G24
Before you begin
Tools
- Precision Phillips #00 screwdriver
- Plastic opening picks
- Spudger
- Suction handle
- Heat gun or hair dryer
- Soft bristle ESD brush
- SIM eject tool
- Tweezers
Parts / materials
- 99% Isopropyl alcohol
- Lint-free microfiber cloth
- Replacement back cover adhesive
Safety
- Ensure the device remains fully powered off before starting work to avoid electrical short circuits.
- Wear protective eyewear when working with liquid alcohol and heated components.
- Perform cleaning in a well-ventilated area to avoid inhaling isopropyl alcohol fumes.
- Do not bend or puncture the lithium-ion battery while working inside the device.
Overview
Step-by-step
- 1
Power off the device
1 minTurn off the phone immediately to prevent short circuits caused by residual moisture.
- 2
Eject the SIM card tray
1 minInsert a SIM eject tool into the hole beside the card tray and press firmly to remove it.
- 3
Heat the rear cover
2 minApply mild heat around the outer edges of the back panel using a heat gun for two minutes to soften the adhesive.
- 4
Slice the back cover adhesive
5 minAttach a suction cup to the lower back panel, pull up gently, and insert an opening pick into the gap to cut the adhesive seal.
- 5
Remove the rear panel
2 minCarefully lift the rear panel off the frame and set it aside, taking care not to rip any remaining tape.
- 6
Unscrew the upper motherboard cover
4 minUse a Phillips #00 screwdriver to unfasten the screws securing the plastic motherboard frame.
- 7
Pry up the motherboard cover
2 minInsert the flat end of a spudger under the motherboard shield and lift it off the chassis.
- 8
Disconnect the battery cable
1 minGently pry the battery press connector straight up from the motherboard to isolate power completely.
- 9
Unscrew and remove the bottom speaker assembly
3 minRemove the Phillips screws holding the lower speaker housing and lift the speaker away from the lower frame.
- 10
Disconnect internal ribbon cables
3 minUnplug the main interconnect flex cable, display cable, and antenna wire connectors from the boards.
- 11
Remove the motherboard and sub-board
3 minGently pry both the main logic board and the lower charging sub-board out of the frame using a spudger.
- 12
Clean corrosion with isopropyl alcohol
10 minDip a soft ESD brush in 99% isopropyl alcohol and scrub away visible corrosion on all circuit boards and connectors.
- 13
Dry all components thoroughly
15 minPlace the cleaned boards on a lint-free microfiber cloth and allow them to air dry completely for at least 15 minutes.
- 14
Reassemble and test the phone
10 minReinstall the boards, reconnect all flex cables and the battery, and power on the phone to verify functionality before final re-sealing.
After your Motorola Moto G24 water damage repair
Power the Moto G24 back on and test the water damage repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto G24 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto G24 repair context in the encyclopedia, or open related DIY guides.
