Phone · Motorola · Moto G24 Power
Motorola Moto G24 Power Speaker Repair
Speaker Repair guide for the Motorola Moto G24 Power
Before you begin
Tools
- Heat gun or hair dryer
- Suction cup tool
- Plastic opening picks
- Plastic spudger
- Precision Phillips #000 screwdriver
- Tweezers
- SIM eject tool
Parts / materials
- Replacement Moto G24 Power speaker module
- Precut back cover adhesive tape
- Isopropyl alcohol (90%+)
Safety
- Wear safety glasses when applying heat and prying plastic components.
- Disconnect the battery cable before handling internal hardware to prevent electrical short circuits.
- Do not puncture or apply pressure to the battery during disassembly.
Overview
Step-by-step
- 1
Power Off the Phone
1 minPress and hold the power button, then tap Power Off to turn off the device completely.
- 2
Eject the SIM Tray
1 minInsert a SIM eject tool into the hole next to the SIM tray, then remove the tray from the device.
- 3
Heat the Back Cover
2 minApply heat around the edges of the back cover using a heat gun for 2 minutes to soften the adhesive.
- 4
Attach Suction Cup
1 minPress a suction cup onto the lower portion of the back panel near the bottom edge.
- 5
Create an Opening Gap
2 minPull up firmly on the suction cup and insert a thin plastic opening pick into the gap.
- 6
Slice the Adhesive
3 minSlide the opening pick around all four edges of the phone to slice through the back panel adhesive.
- 7
Remove the Back Cover
1 minLift the back cover off the phone frame and set it aside.
- 8
Unscrew Lower Module
3 minUse a Phillips #000 screwdriver to remove the screws securing the lower loudspeaker housing.
- 9
Pry Up Speaker Housing
2 minInsert a spudger beneath the edge of the loudspeaker assembly and gently pop it out of place.
- 10
Disconnect the Battery
1 minPry up the battery press connector from the motherboard to cut power before proceeding.
- 11
Extract Old Speaker
2 minUse tweezers to carefully lift the original speaker unit out of the lower plastic housing.
- 12
Install New Speaker
2 minPlace the replacement speaker into the housing, ensuring the spring contacts line up properly.
- 13
Reconnect the Battery
1 minAlign and press down on the battery connector until it snaps firmly into place.
- 14
Reinstall Speaker Housing
2 minSet the loudspeaker housing back over the bottom sub-board and press down firmly.
- 15
Fasten Housing Screws
3 minReinsert and tighten all Phillips screws to secure the loudspeaker module in place.
- 16
Apply New Adhesive
3 minPlace precut adhesive strips along the inner frame perimeter to prepare for closing.
- 17
Reattach Back Cover
2 minAlign the back cover with the body and press firmly along all edges to seat the adhesive.
- 18
Reinsert the SIM Tray
1 minPush the SIM card tray back into its slot until it sits flush against the frame.
After your Motorola Moto G24 Power speaker repair
Power the Moto G24 Power back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto G24 Power job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto G24 Power repair context in the encyclopedia, or open related DIY guides.
