Phone · Motorola · Moto G24 Power
Motorola Moto G24 Power Logic Board Repair
Logic Board Repair guide for the Motorola Moto G24 Power
Before you begin
Tools
- Heat gun or hair dryer
- Phillips #00 screwdriver
- Plastic prying tools
- Spudger tool
- Suction cup tool
- Tweezers
- SIM eject pin
- Opening picks
Parts / materials
- Isopropyl alcohol (99%)
- Replacement back cover adhesive tape
- Thermal paste
Safety
- Disconnect the battery cable before handling any board components to prevent electrical short circuits.
- Wear safety glasses while heating the device to protect your eyes from debris or glass.
- Do not use metal tools directly on ribbon cable connectors to avoid tearing pins.
Overview
Step-by-step
- 1
Power Off Device
1 minPress and hold the power button, then select power off to safely shut down the Moto G24 Power.
- 2
Eject SIM Card Tray
1 minInsert a SIM eject pin into the hole on the side of the phone to release the tray.
- 3
Heat Back Cover
3 minApply heat evenly around the rear cover edges for 2 minutes to soften the adhesive layer.
- 4
Slice Back Cover Adhesive
4 minAttach a suction cup near the bottom edge, pull gently, and insert a plastic opening pick to slice through the adhesive.
- 5
Remove Back Cover
2 minSlide the opening pick around all sides to separate the back cover, then lift it clear of the frame.
- 6
Unscrew Upper Midframe
3 minUse a Phillips #00 screwdriver to remove all visible screws securing the motherboard protective cover.
- 7
Detach Upper Midframe
2 minInsert a spudger under the edge of the upper midframe and gently pry it off the chassis.
- 8
Disconnect Battery Cable
1 minPry the battery connector straight up from its socket on the logic board using a plastic spudger.
- 9
Disconnect Display Cable
1 minUse the flat end of a spudger to disconnect the display ribbon cable from the logic board.
- 10
Disconnect Interconnect Cable
1 minUnplug the main sub-board ribbon cable from the bottom portion of the logic board.
- 11
Disconnect Antenna Cable
2 minGently unsnap the coaxial antenna cable connector from the logic board using precision tweezers.
- 12
Remove Front Camera
2 minDisconnect the front-facing camera flex cable and lift the camera module out of its housing notch.
- 13
Unscrew Logic Board
2 minRemove any remaining Phillips screws anchoring the logic board directly to the internal frame.
- 14
Lift Out Logic Board
2 minPry up the edges of the logic board gently with a plastic spudger and remove it from the phone.
- 15
Insert Replacement Logic Board
3 minPosition the new logic board into the frame chassis and press lightly until it rests flat in place.
After your Motorola Moto G24 Power logic board repair
Power the Moto G24 Power back on and test the logic board repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto G24 Power job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto G24 Power repair context in the encyclopedia, or open related DIY guides.
