Phone · Motorola · Moto G200 5G
Motorola Moto G200 5G Speaker Repair
Speaker Repair guide for the Motorola Moto G200 5G
Before you begin
Tools
- Phillips #000 screwdriver
- Heat gun or iOpener
- Suction cup
- Plastic opening picks
- Spudger
- SIM eject tool
- Tweezers
Parts / materials
- Replacement Moto G200 loudspeaker module
- Pre-cut back cover adhesive
- 99% Isopropyl alcohol
Safety
- Wear eye protection when heating glass or hard plastic panels.
- Do not insert picks deeper than 3mm to avoid damaging internal flex cables.
- Always disconnect the battery before servicing internal modules.
Overview
Step-by-step
- 1
Remove the SIM card tray
1 minInsert a SIM eject tool into the hole next to the tray on the bottom edge. Press firmly to pop out the tray, then remove it.
- 2
Heat the back cover
2 minApply a heat gun or iOpener around the perimeter of the back cover for 2 minutes to soften the adhesive.
- 3
Attach a suction cup
1 minPress a suction cup onto the lower section of the back cover and pull upward firmly to create a small gap.
- 4
Slice the perimeter adhesive
4 minInsert an opening pick into the gap and slide it slowly along all edges to separate the rear cover glue.
- 5
Detach the rear cover
1 minCarefully lift the rear cover off the chassis and set it aside.
- 6
Unscrew the upper motherboard cover
3 minUse a Phillips #000 screwdriver to remove the screws securing the plastic upper cover.
- 7
Remove the upper cover
1 minUse a spudger to gently pry up and remove the motherboard shield.
- 8
Disconnect the battery cable
1 minPry the battery connector straight up from its motherboard socket using a plastic spudger.
- 9
Unscrew the lower speaker housing
2 minRemove the Phillips screws securing the loudspeaker assembly at the bottom of the device.
- 10
Remove the old loudspeaker
2 minInsert a spudger under the edge of the loudspeaker module and lift it out of the chassis.
- 11
Install the replacement loudspeaker
2 minPlace the new loudspeaker into the lower recess and press down gently until it fits flush.
- 12
Secure the speaker housing
2 minReinstall the lower housing cover and tighten the Phillips screws to hold it in place.
- 13
Reconnect the battery
1 minAlign the battery flex connector over its socket and press firmly until it snaps into place.
- 14
Reinstall the upper motherboard cover
3 minPosition the upper shield over the motherboard and drive in the retaining screws.
- 15
Clean residual adhesive
4 minClean the old glue off the frame using isopropyl alcohol, then apply fresh rear cover adhesive.
- 16
Reattach the rear cover
2 minAlign the rear cover with the frame and press firmly around all edges to secure the bond.
- 17
Reinsert the SIM card tray
1 minPush the SIM card tray back into its slot on the bottom edge until flush.
After your Motorola Moto G200 5G speaker repair
Power the Moto G200 5G back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto G200 5G job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto G200 5G repair context in the encyclopedia, or open related DIY guides.
