Phone · Motorola · Moto G Stylus 4G 2022
Motorola Moto G Stylus 4G 2022 Logic Board Repair
Logic Board Repair guide for the Motorola Moto G Stylus 4G 2022
Before you begin
Tools
- Heat gun or hair dryer
- Phillips #000 screwdriver
- Plastic prying tools
- Suction cup tool
- Spudger tool
- Tweezers
- SIM eject tool
Parts / materials
- Replacement back cover adhesive
- Isopropyl alcohol (99%)
Safety
- Wear protective eye safety glasses when using heat tools and plastic picks.
- Disconnect the battery press connector before touching or disconnecting any other internal components.
- Do not bend, puncture, or apply pressure directly to the lithium-ion battery.
Overview
Step-by-step
- 1
Remove the Stylus
1 minPress inward on the integrated stylus until it clicks, then pull it completely out from the bottom slot.
- 2
Eject the SIM Tray
1 minInsert a SIM eject tool or thin pin into the hole on the left edge of the phone to remove the card tray.
- 3
Heat the Rear Cover
3 minApply heat evenly around the outer edges of the back panel using a heat gun for approximately two minutes.
- 4
Attach the Suction Cup
2 minPlace a suction cup onto the lower portion of the rear panel and pull upward to create a small gap.
- 5
Slice the Rear Adhesive
4 minInsert a plastic pick into the gap and slice along all four edges of the back cover to cut the adhesive.
- 6
Remove the Rear Cover
1 minLift the rear cover away from the chassis carefully and place it on a clean workspace.
- 7
Unscrew the Upper Shield
3 minRemove the eleven Phillips #000 screws securing the plastic motherboard shield cover.
- 8
Pry Off Upper Shield
2 minInsert a spudger under the notch in the motherboard shield and gently lever it off the chassis.
- 9
Disconnect the Battery
1 minUse the flat end of a spudger to snap the battery press connector straight up off the motherboard.
- 10
Disconnect Interconnect Cable
1 minUnplug the main sub-board flex cable press connector located on the lower section of the logic board.
- 11
Disconnect Display Cable
1 minPry up the display flex cable press connector from its socket on the center of the motherboard.
- 12
Disconnect Antenna Cables
2 minUse fine-tip tweezers to carefully lift the white and black coaxial antenna headers off the logic board.
- 13
Remove Board Retention Screws
1 minUnscrew the single Phillips #000 screw holding the top left corner of the logic board to the frame.
- 14
Pry Up Logic Board
2 minInsert a spudger under the top edge of the motherboard and lift it upward out of the phone housing.
- 15
Transfer Front Camera
2 minDisconnect the front-facing camera flex connector and transfer the camera unit to the new logic board.
After your Motorola Moto G Stylus 4G 2022 logic board repair
Power the Moto G Stylus 4G 2022 back on and test the logic board repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto G Stylus 4G 2022 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto G Stylus 4G 2022 repair context in the encyclopedia, or open related DIY guides.
