Phone · Motorola · Moto G Power 5G 2023
Motorola Moto G Power 5G 2023 Speaker Repair
Speaker Repair guide for the Motorola Moto G Power 5G 2023
Before you begin
Tools
- Phillips #00 screwdriver
- Plastic opening tools
- Suction cup
- Heat gun or hairdryer
- Tweezers
- Spudger
- SIM card eject tool
Parts / materials
- Replacement Moto G Power 5G 2023 loudspeaker assembly
- Pre-cut back cover adhesive strip
- Isopropyl alcohol (90%+)
- Cleaning wipes
Safety
- Power down the smartphone completely before starting disassembly.
- Use caution when heating the device to prevent damage to internal components.
- Use only non-conductive plastic spudgers around the battery to prevent electrical short circuits.
Overview
Step-by-step
- 1
Eject the SIM card tray
1 minInsert a SIM eject tool into the pinhole on the left side of the phone and remove the SIM tray.
- 2
Heat the back panel
2 minUse a heat gun or hairdryer to warm the rear edges of the phone for 2 minutes to soften the perimeter adhesive.
- 3
Attach a suction handle
1 minPlace a suction cup near the bottom edge of the back panel and pull upward firmly to create a seam.
- 4
Slice the edge adhesive
3 minInsert a plastic opening pick into the gap and slide it along the perimeter to slice through the glue.
- 5
Lift off the back cover
2 minCarefully separate the back cover from the frame and place it aside.
- 6
Unscrew the upper midframe cover
3 minRemove the Phillips #00 screws securing the plastic motherboard bracket to the chassis.
- 7
Remove the upper midframe cover
2 minPry up the edges of the motherboard cover using a spudger and remove it from the device.
- 8
Disconnect the battery cable
1 minUse a plastic spudger to pop the battery connector straight up from its motherboard socket.
- 9
Unscrew the bottom speaker module
2 minRemove the Phillips #00 screws securing the loudspeaker enclosure at the bottom of the device.
- 10
Remove the old loudspeaker
2 minInsert a plastic opening tool under the speaker module edge and gently pry it out of the recess.
- 11
Insert the replacement loudspeaker
2 minAlign the new speaker module into the lower frame housing and press down until it sits flush.
- 12
Fasten the speaker screws
2 minReinstall and tighten the Phillips #00 screws to firmly secure the speaker module.
- 13
Reconnect the battery
1 minAlign the battery press connector over its socket and press firmly until it snaps into place.
- 14
Reinstall the upper midframe cover
3 minPosition the motherboard cover back over the top board and secure all Phillips #00 screws.
- 15
Reseal and attach the back cover
4 minClean off old adhesive, apply fresh back panel adhesive tape, and press the rear panel firmly back onto the chassis.
After your Motorola Moto G Power 5G 2023 speaker repair
Power the Moto G Power 5G 2023 back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto G Power 5G 2023 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto G Power 5G 2023 repair context in the encyclopedia, or open related DIY guides.
