Phone · Motorola · Moto G Power 5G 2023
Motorola Moto G Power 5G 2023 Logic Board Repair
Logic Board Repair guide for the Motorola Moto G Power 5G 2023
Before you begin
Tools
- Precision screwdriver set (Phillips #00)
- Heat gun or hair dryer
- Suction cup tool
- Plastic prying tools
- Spudger tool
- Tweezers
- SIM eject tool
Parts / materials
- Isopropyl alcohol (91%+)
- Replacement back panel adhesive strip
Safety
- Power off the phone completely before starting the repair.
- Wear safety glasses while working near glass or using heating devices.
- Do not use metallic tools directly against the lithium-ion battery.
Overview
Step-by-step
- 1
Eject SIM Tray
1 minInsert a SIM eject tool into the hole beside the card tray on the left edge of the device. Push inward firmly to pop the tray out, then slide it out completely.
- 2
Heat Back Panel
3 minApply heat from a heat gun set to low warmth around all edges of the rear panel for approximately two minutes to soften the internal adhesive.
- 3
Attach Suction Cup
2 minPress a suction cup firmly onto the lower portion of the rear panel, then pull upward gently to create a slight gap between panel and frame.
- 4
Slice Rear Panel Adhesive
4 minInsert a plastic prying pick into the gap and slowly slide it along all sides to slice through the adhesive perimeter.
- 5
Lift Off Rear Panel
2 minCarefully pull the rear panel off the frame completely and set it aside.
- 6
Unscrew Motherboard Frame
3 minRemove the Phillips #00 screws holding the upper plastic motherboard frame in place.
- 7
Remove Upper Frame Bracket
2 minPry up the upper plastic shield using a spudger and lift it off the motherboard.
- 8
Disconnect Battery Connector
1 minUse the edge of a plastic spudger to pry the battery flex cable straight up off its motherboard socket.
- 9
Disconnect Display Cable
1 minPry the display flex cable connector straight up from the motherboard using a plastic spudger.
- 10
Disconnect Interconnect Cable
1 minDisconnect the main lower interconnect ribbon cable press connector from the logic board.
- 11
Disconnect Front Camera
2 minUnplug the front-facing selfie camera flex cable from the top section of the logic board.
- 12
Disconnect Antenna Cables
2 minUse fine tweezers to gently unsnap the coaxial antenna cable heads from the logic board.
- 13
Unscrew Logic Board
2 minRemove any remaining Phillips #00 screws securing the logic board directly to the frame assembly.
- 14
Extract Logic Board
3 minGently lift the logic board up from its lower end and maneuver it carefully out of the chassis.
After your Motorola Moto G Power 5G 2023 logic board repair
Power the Moto G Power 5G 2023 back on and test the logic board repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto G Power 5G 2023 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto G Power 5G 2023 repair context in the encyclopedia, or open related DIY guides.
