Phone · Motorola · Moto G Power 2022
Motorola Moto G Power 2022 Screen Replacement
Screen Replacement guide for the Motorola Moto G Power 2022
Before you begin
Tools
- Phillips #00 Screwdriver
- Heat Gun or Hair Dryer
- Plastic Opening Picks
- Spudger Tool
- Suction Cup Tool
- SIM Eject Tool
- Tweezers
Parts / materials
- Motorola Moto G Power 2022 Replacement Screen
- Pre-cut Display Adhesive Strips
- Isopropyl Alcohol (99%)
Safety
- Wear safety glasses to shield your eyes from glass splinters when removing cracked glass.
- Disconnect the battery before unplugging or attaching internal flex cables.
- Do not puncture or bend the lithium-ion battery during disassembly.
Overview
Step-by-step
- 1
Power Off the Phone
1 minPress and hold the power button on the right edge, then tap Power Off on the screen.
- 2
Remove the SIM Card Tray
1 minInsert a SIM eject tool into the small hole on the left edge to pop out the tray.
- 3
Heat the Rear Cover
2 minWarm the outer edges of the back cover with a heat gun for 2 minutes to soften the adhesive.
- 4
Slice Rear Cover Adhesive
4 minInsert a thin plastic opening pick under the lower seam and slide it around the perimeter.
- 5
Lift Back Cover Gently
2 minPivot the rear cover open from the right side, taking care not to strain the fingerprint sensor cable.
- 6
Remove Motherboard Cover Screws
3 minUse a Phillips #00 screwdriver to remove the screws securing the upper plastic motherboard shield.
- 7
Detach Motherboard Cover
2 minGently pry up the motherboard cover with a spudger and remove it from the frame.
- 8
Disconnect Fingerprint Cable
1 minUse the flat end of a spudger to pop the fingerprint reader flex connector off the motherboard.
- 9
Disconnect the Battery
1 minPry the battery flex connector straight up from its socket to prevent electrical shorts.
- 10
Remove Speaker Module Screws
3 minUnscrew the Phillips #00 screws holding the lower speaker enclosure at the bottom of the phone.
- 11
Remove Speaker Enclosure
2 minLift the speaker housing out of the lower chassis using plastic prying tools.
- 12
Disconnect Display Ribbon Cable
2 minUnplug the screen flex connector from the lower daughterboard and upper main board.
- 13
Heat Front Screen Assembly
3 minApply heat evenly across the front glass display for 3 minutes to relax the bezel adhesive.
- 14
Separate Glass Display Assembly
5 minAttach a suction cup to the glass, lift slightly, and slice the adhesive perimeter with an opening pick.
- 15
Thread Flex Cable and Remove Screen
2 minCarefully guide the attached display ribbon cable through the frame slot as you lift the screen away.
- 16
Clean Frame Perimeter
4 minScrape off residual adhesive and broken glass shards from the frame recess using a spudger and isopropyl alcohol.
- 17
Apply New Frame Adhesive
3 minLay fresh double-sided adhesive strips along the entire inner border of the phone frame.
- 18
Position New Display Panel
3 minFeed the new screen's flex cable through the slot and press the display assembly firmly into the frame.
- 19
Reconnect Display Cable and Battery
2 minAttach the display ribbon cable to the board and snap the battery connector back into place.
- 20
Reinstall Internal Covers and Screws
4 minPlace the speaker enclosure and motherboard bracket back onto the chassis, then tighten all Phillips screws.
- 21
Reconnect Fingerprint Sensor and Seal Cover
3 minPlug in the fingerprint sensor flex, align the back cover, and press firmly along the outer edges to seal.
- 22
Reinsert SIM Card Tray
1 minSlide the SIM card tray back into its slot on the side of the phone until it sits flush.
After your Motorola Moto G Power 2022 screen replacement
Power the Moto G Power 2022 back on and test the screen replacement function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto G Power 2022 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto G Power 2022 repair context in the encyclopedia, or open related DIY guides.
