Phone · Motorola · Moto G Play 2024
Motorola Moto G Play 2024 Speaker Repair
Speaker Repair guide for the Motorola Moto G Play 2024
Before you begin
Tools
- Precision screwdriver set
- Plastic opening tools
- Anti-static wrist strap
- Tweezers
- SIM eject tool
- Heat gun or iOpener
- Spudger
Parts / materials
- Replacement Motorola Moto G Play 2024 loudspeaker assembly
- 99% Isopropyl alcohol
- Pre-cut back cover adhesive tape
Safety
- Wear eye protection when heating and prying plastic panels.
- Do not puncture or bend the internal lithium-ion battery.
- Use an anti-static wrist strap to prevent electrostatic damage to delicate board contacts.
Overview
Step-by-step
- 1
Power Down the Phone
1 minPress and hold the power button, then tap Power Off to completely turn off the device.
- 2
Eject the SIM Tray
1 minInsert a SIM eject tool into the pinhole on the left edge of the phone to pop out the SIM tray.
- 3
Heat the Rear Panel Edges
2 minApply a hot heat gun or iOpener around the outer edges of the back cover for two minutes to soften the internal adhesive.
- 4
Create a Gap with an Opening Pick
2 minInsert a thin plastic opening pick into the seam between the rear cover and the display frame near the bottom corner.
- 5
Slice the Rear Cover Adhesive
4 minSlide the pick around all four edges of the device to unclip the perimeter plastic clips and cut through the adhesive.
- 6
Remove the Back Cover
1 minGently lift the back cover off the frame and lay it face down.
- 7
Unscrew the Loudspeaker Assembly
3 minUse a Phillips #00 screwdriver to remove the seven screws securing the lower loudspeaker housing to the sub-board.
- 8
Pry Up the Speaker Module
2 minInsert a spudger underneath the notched edge of the loudspeaker assembly and gently lever it out of the frame.
- 9
Clean the Sub-Board Spring Contacts
2 minLightly dab a cotton swab with 99% isopropyl alcohol and clean the gold contact pads on the underlying sub-board.
- 10
Set the New Loudspeaker
2 minAlign the replacement loudspeaker module over the bottom frame recess and press down firmly until it sits flush.
- 11
Fasten the Loudspeaker Screws
3 minReinstall the seven Phillips #00 screws to securely anchor the loudspeaker module in place.
- 12
Reseal the Rear Panel
3 minAlign the back cover over the chassis and press firmly along all edges until every plastic clip snaps shut.
- 13
Reinsert the SIM Card Tray
1 minPush the SIM card tray back into its slot on the side of the phone until it clicks shut.
After your Motorola Moto G Play 2024 speaker repair
Power the Moto G Play 2024 back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto G Play 2024 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto G Play 2024 repair context in the encyclopedia, or open related DIY guides.
