Phone · Motorola · G64 5G
Motorola G64 5G Speaker Repair
Speaker Repair guide for the Motorola G64 5G
Before you begin
Tools
- Precision screwdriver set
- Plastic opening tools
- Tweezers
- Heat gun or iOpener
- Suction cup
- Opening picks
- SIM eject tool
Parts / materials
- Motorola G64 5G loudspeaker module
- Custom back panel adhesive strips
- Isopropyl alcohol (91%+)
Safety
- Wear safety glasses to protect eyes from potential flying debris during prying.
- Always disconnect the battery before removing or installing internal components.
- Do not bend or puncture the battery with metal tools.
Overview
Step-by-step
- 1
Power off the phone
1 minPress and hold the power button, then select power off to ensure the phone is entirely turned off.
- 2
Eject the SIM tray
1 minInsert a SIM eject tool into the hole on the left edge of the phone to pop out the SIM card tray.
- 3
Heat the back cover
2 minApply a heat gun or heated iOpener around the edges of the back cover for two minutes to soften the adhesive.
- 4
Attach a suction cup
1 minPlace a suction cup near the lower edge of the rear panel and pull upward to create a small gap.
- 5
Insert an opening pick
1 minSlide an opening pick into the gap between the plastic back cover and the frame.
- 6
Slice the perimeter adhesive
3 minMove the pick carefully around all four edges of the back cover to cut through the seal.
- 7
Remove the back panel
1 minLift the rear panel away from the frame and set it aside.
- 8
Unscrew the midframe assembly
3 minUse a Phillips #00 screwdriver to remove all screws securing the plastic midframe and loudspeaker cover.
- 9
Unclip the midframe
2 minInsert a spudger under the midframe edge and gently pry to release its plastic clips.
- 10
Disconnect the battery flex cable
1 minPry the battery connector directly up from the motherboard using a plastic spudger to cut power.
- 11
Pry up the old loudspeaker
2 minInsert a flat spudger underneath the lower speaker assembly and lift it out from the frame cavity.
- 12
Insert the replacement loudspeaker
1 minSet the new loudspeaker module into the lower frame housing and press down until it sits flat.
- 13
Reconnect the battery cable
1 minAlign the battery connector over its socket and press firmly until it snaps into place.
- 14
Reattach the midframe
2 minPosition the midframe cover over the phone and press along the edges to engage the plastic tabs.
- 15
Secure the Phillips screws
3 minReinstall and tighten all Phillips #00 screws around the frame and lower speaker shield.
- 16
Apply new cover adhesive
2 minLay fresh custom-cut adhesive strips along the outer ledge of the rear frame.
- 17
Seal the back cover
2 minAlign the rear panel over the frame and press firmly along the perimeter to adhere it in place.
After your Motorola G64 5G speaker repair
Power the G64 5G back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola G64 5G job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola G64 5G repair context in the encyclopedia, or open related DIY guides.
