Phone · Motorola · G62 5G
Motorola G62 5G Screen Replacement
Screen Replacement guide for the Motorola G62 5G
Before you begin
Tools
- Heat gun or hair dryer
- Suction cup tool
- Plastic prying tools
- Spudger tool
- Phillips #00 precision screwdriver
- Tweezers
- SIM eject pin
Parts / materials
- Replacement Motorola G62 5G screen assembly
- Double-sided adhesive strips
- Isopropyl alcohol (90% or higher)
Safety
- Wear protective safety glasses to guard against flying glass fragments from cracked display.
- Do not heat the phone beyond 80°C (176°F) to avoid thermal damage to the internal battery.
- Disconnect the battery press connector immediately after opening the housing to prevent shorts.
Overview
Step-by-step
- 1
Power Off Device
1 minPress and hold the power button, then select Power Off on the screen before beginning.
- 2
Remove SIM Card Tray
1 minInsert a SIM eject pin into the small hole on the left edge of the phone to pop out the tray.
- 3
Heat Rear Cover
2 minApply heat evenly around the perimeter of the back cover for 2 minutes to soften the rear adhesive.
- 4
Attach Suction Cup
1 minPlace a suction cup near the bottom edge of the back panel and pull up gently to create a gap.
- 5
Insert Opening Pick
2 minSlide a plastic opening pick into the gap created between the rear panel and the phone frame.
- 6
Slice Rear Adhesive
3 minSlide the pick around all four edges of the phone to separate the back cover adhesive completely.
- 7
Remove Rear Panel
1 minLift the rear panel away from the frame and set it aside safely.
- 8
Unscrew Midframe Screws
4 minUse a Phillips #00 screwdriver to remove all visible screws securing the plastic midframe bezel.
- 9
Pry Up Midframe
2 minInsert a spudger under the edge of the plastic midframe and pry gently to release its perimeter clips.
- 10
Detach Midframe Assembly
1 minLift the midframe structure off the chassis and set it aside.
- 11
Disconnect Battery Cable
1 minUse the flat end of a spudger to pry up the battery flex connector from the motherboard.
- 12
Disconnect Screen Cable
1 minPry up the display flex cable connector located on the main logic board.
- 13
Heat Front Screen
3 minUse a heat gun or hairdryer on low heat around the edges of the display glass for 2 to 3 minutes.
- 14
Apply Front Suction Cup
1 minPress the suction cup onto the cracked glass screen near the bottom edge.
- 15
Slice Screen Adhesive
4 minWork an opening pick around the entire perimeter between the glass display and the chassis.
- 16
Lift Damaged Screen
2 minPivot the screen up and carefully guide the flex cable through the slot in the frame.
- 17
Clean Frame Residue
5 minScrape off residual adhesive and glass bits from the inner frame ledge using tweezers and isopropyl alcohol.
- 18
Apply Frame Adhesive
3 minLay fresh double-sided adhesive strips along the perimeter channel of the frame.
- 19
Seat New Display
2 minFeed the new display cable through the frame slot and press the screen firmly into the recess.
- 20
Connect Screen Cable
1 minPress the display flex connector straight down onto its motherboard socket until it clicks.
- 21
Reconnect Battery Cable
1 minPress the battery connector down onto the motherboard to reconnect power.
- 22
Reinstall Midframe
2 minAlign the plastic midframe over the motherboard and lower board, pressing down to snap clips in place.
- 23
Secure Midframe Screws
3 minReinstall all Phillips #00 screws into the midframe until snug.
- 24
Reattach Rear Cover
3 minApply new adhesive to the rear cover border and press the back cover firmly onto the frame.
- 25
Reinsert SIM Tray
1 minPush the SIM card tray back into the slot on the left edge until flush.
After your Motorola G62 5G screen replacement
Power the G62 5G back on and test the screen replacement function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola G62 5G job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola G62 5G repair context in the encyclopedia, or open related DIY guides.
