Skip to main content

Phone · Motorola · G4 Plus

Motorola G4 Plus Speaker Repair

Speaker Repair guide for the Motorola G4 Plus

Moderate
~34 min
16 steps

Before you begin

Tools

  • Phillips #00 screwdriver
  • Torx T3 screwdriver
  • Plastic spudger
  • Plastic prying tools
  • Precision tweezers
  • Clean workspace mat

Parts / materials

  • Replacement Moto G4 Plus speaker module
  • Isopropyl alcohol
  • Cotton swabs

Safety

  • Wear an anti-static wrist strap to prevent electrostatic discharge damage to internal components.
  • Disconnect the battery before touching internal electronics to prevent accidental short circuits.
  • Keep small screws organized to ensure correct screws are reinstalled in their matching holes.

Overview

# Motorola G4 Plus Speaker Repair Repair Guide Action-specific speaker repair walkthrough for the Motorola G4 Plus. About 34 minutes across 16 steps. This DIY guide walks through speaker repair on the Motorola G4 Plus (Moto G series phone). Before you open the device, confirm the exact model number on the Motorola settings screen or rear housing so your replacement part matches the G4 Plus specifically—not a similar Moto G sibling. Most DIY techs finish this Motorola G4 Plus speaker repair in about 34 minutes when parts and tools are ready. Difficulty is rated intermediate for this model. Recommended tools for this Motorola G4 Plus job: Phillips #00 screwdriver, Torx T3 screwdriver, Plastic spudger, Plastic prying tools, Precision tweezers, Clean workspace mat. Parts and supplies: Replacement Moto G4 Plus speaker module, Isopropyl alcohol, Cotton swabs. Power the G4 Plus off completely, remove SIMs/SD cards if present, and work on a clean, well-lit surface with a magnetic mat for screws. If a step feels wrong for your Motorola G4 Plus, stop and compare the connector layout to the photos in this guide. When you prefer a same-day pro repair in Seattle instead, LML Repair can handle speaker repair for this model with tested parts and a workmanship warranty.

Step-by-step

  1. 1

    Power Down Device

    1 min

    Press and hold the power button, then tap Power Off on the screen to completely shut down the device.

  2. 2

    Remove Rear Cover

    2 min

    Insert a plastic prying tool into the notch at the bottom edge and lift the back cover off the body.

  3. 3

    Remove SIM Trays

    1 min

    Pull out any installed SIM cards and microSD card from their respective slots.

  4. 4

    Remove Midframe Screws

    4 min

    Use a Torx T3 screwdriver to remove the visible perimeter screws securing the inner midframe.

  5. 5

    Peel Rubber Covers

    2 min

    Use fine tweezers to gently peel away the small rubber dampeners covering the hidden screws.

  6. 6

    Remove Hidden Screws

    2 min

    Unscrew the remaining hidden Phillips #00 screws located underneath the rubber covers.

  7. 7

    Unclip Rear Midframe

    3 min

    Slide a plastic opening pick around the edge seam to unclip the midframe from the display assembly.

  8. 8

    Lift Off Midframe

    1 min

    Carefully lift the midframe away from the phone body and set it face down on your mat.

  9. 9

    Disconnect Battery Cable

    2 min

    Pry up the battery press connector from the motherboard using a plastic spudger to cut power.

  10. 10

    Remove Damaged Speaker

    2 min

    Insert tweezers under the edge of the speaker module and pry it out of its midframe recess.

  11. 11

    Clean Speaker Recess

    2 min

    Clear any leftover adhesive or debris from the speaker cavity using isopropyl alcohol on a cotton swab.

  12. 12

    Insert Replacement Speaker

    2 min

    Align the gold contact pins on the new speaker module with the housing and press it firmly into place.

  13. 13

    Reconnect Battery Cable

    1 min

    Align the battery press connector over its socket and press down until it clicks securely.

  14. 14

    Reattach Rear Midframe

    3 min

    Position the midframe onto the chassis and press around all edges until the plastic clips snap together.

  15. 15

    Fasten Frame Screws

    4 min

    Reinstall all Torx T3 and Phillips #00 screws back into their original locations.

  16. 16

    Reinstall Back Cover

    2 min

    Reinsert your cards, then press the plastic rear cover firmly onto the phone until fully seated.

After your Motorola G4 Plus speaker repair

Power the G4 Plus back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola G4 Plus job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.

Keep learning

Explore more Motorola G4 Plus repair context in the encyclopedia, or open related DIY guides.

logo_footer

Stay in the loop

Get new guides, reviews, and repair news.

© 2026 LML Repair. All rights reserved.