Phone · Motorola · G24
Motorola G24 Speaker Repair
Speaker Repair guide for the Motorola G24
Before you begin
Tools
- SIM eject tool
- Heat gun or hair dryer
- Suction cup tool
- Plastic prying tools
- Precision screwdriver set (Phillips #000)
- Spudger tool
- Tweezers
Parts / materials
- Replacement Motorola Moto G24 loudspeaker module
- Isopropyl alcohol (99%)
- B-7000 frame adhesive or pre-cut tape
- Lint-free cloth
Safety
- Power off the phone completely before beginning disassembly.
- Wear safety glasses when applying heat to prevent injury from dust or loose debris.
- Work in a well-ventilated area when using adhesive or solvent cleaners.
Overview
Step-by-step
- 1
Eject the SIM Card Tray
1 minInsert a SIM eject tool into the hole on the left edge of the phone until the tray pops out. Remove the SIM tray completely from the device.
- 2
Heat the Back Cover
2 minApply a heat gun or hair dryer evenly along the outer edges of the back cover for two minutes to soften the adhesive.
- 3
Attach the Suction Cup
1 minPlace a suction cup near the bottom edge of the back panel and pull upward to create a slight gap.
- 4
Insert an Opening Pick
1 minSlide a thin plastic opening pick into the seam between the back cover and the phone frame.
- 5
Slice the Perimeter Adhesive
3 minGuide the pick slowly along all four edges of the back cover to slice through the softened adhesive.
- 6
Remove the Back Cover
1 minLift the back cover off the frame and set it aside in a safe location.
- 7
Unscrew the Loudspeaker Assembly
2 minUse a Phillips #000 screwdriver to remove the screws holding the lower speaker module to the chassis.
- 8
Pry Up the Speaker Module
2 minInsert the flat end of a spudger under the edge of the loudspeaker assembly and gently lift it out.
- 9
Clean the Contact Area
1 minWipe the exposed contact pads on the lower board with a lint-free cloth lightly dampened with isopropyl alcohol.
- 10
Position the New Speaker
2 minAlign the replacement loudspeaker unit directly over the bottom housing recess and press it gently down into place.
- 11
Secure the Speaker Screws
2 minReinstall and tighten the Phillips #000 screws to firmly attach the new speaker module.
- 12
Apply Back Cover Adhesive
3 minApply a thin layer of B-7000 adhesive or double-sided phone repair tape along the perimeter of the frame.
- 13
Reattach the Back Cover
2 minAlign the back panel with the frame and press firmly along all edges for one minute to ensure a complete seal.
- 14
Reinsert the SIM Tray
1 minPush the SIM card tray back into its slot on the side of the phone until it sits flush.
After your Motorola G24 speaker repair
Power the G24 back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola G24 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola G24 repair context in the encyclopedia, or open related DIY guides.
